Electronics Forum | Sun Aug 02 10:29:28 EDT 2009 | Sean
Hi all, If we are using non clean flux, what are the wave soldering parameters that we should monitor using SPC control chart? If not mistaken pre-heat is one of the important parameter that we should control.. Thanks, Sean
Electronics Forum | Wed Aug 12 09:01:53 EDT 2009 | gregoryyork
Hi Can you be a little more specific with wave solder machine name and method of applying flux and if lead free or not then can come back with some meaningfull figures Cheers GREG BLT
Electronics Forum | Tue Aug 04 22:57:07 EDT 2009 | davef
Wikipedia: http://en.wikipedia.org/wiki/Automated_optical_inspection Facebook: http://www.youtube.com/watch?v=So_DMNGZHAQ
Electronics Forum | Tue Aug 04 13:44:05 EDT 2009 | swag
Check your DIP switch settings on new driver. Not sure about calibration. Try QMPM for password.
Electronics Forum | Tue Aug 04 14:43:12 EDT 2009 | kpm135
Thank you very much SWAG that password did the trick. Got us into the calibration menu and we were able to calibrate the z-axis and snugger height and got it to work. Thanks again
Electronics Forum | Tue Aug 04 15:53:27 EDT 2009 | emanuel
Maybe it will sound a little obsolete, but I need to know if there is or where to get a software package to be used with a CAM/ALOT dispenser for solder paste. Is there a dedicated program or any kind of gerber translator out there?
Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Thu Aug 06 13:54:13 EDT 2009 | lockj69w
We have this problem typically after a PM is performed and it is usually due to too much grease on the linear guide.
Electronics Forum | Mon Aug 10 12:28:17 EDT 2009 | davef
We don't know dip about your Linear Tech LGA118, but we agree with published reports that say you should have between 4800 and 7000 thou^3 of paste on the pad for a LGA. These volumes were analyzed based on volumes found successful for CGA and then e
Electronics Forum | Tue Aug 11 15:19:41 EDT 2009 | aj
you gotta ask WHY? thankfully dont place these but I wud imagine you have referenced the datasheet for solder thickness etc. How is your placement? You say ypu place 17 of these? are you seeing shorts on all of them or a select few? aj
.gif)
