Electronics Forum | Wed Sep 15 23:48:43 EDT 2010 | mily
We drilled a hole in the centre of the LGA and put the thermocouple inside, so we measure the exact temperature between PCB and device. http://www.jewellerybeadsale.com/
Electronics Forum | Fri Sep 17 11:55:31 EDT 2010 | qualityguy
All, Get the material data sheets, lot numbers of ink, supplier's process flow, bare boards with ink lot applied ( qty 20), Contact the ink supplier and perform a 3company DOE.
Electronics Forum | Wed Sep 08 11:05:23 EDT 2010 | dnebel
I've used Vtek equipment for years and it does the job. Make sure to leave some space to warehouse reels of different carrier tapes.
Electronics Forum | Tue Sep 21 09:20:36 EDT 2010 | vleasher
Any suggestions on good suppliers of the carrier tape and mylar? I'm attempting to get a handle on the price of consumables related to the addition of the machine.
Electronics Forum | Tue Sep 28 15:33:53 EDT 2010 | babe7362000
V-Tek TM-50 is a great machine. We have had it about 5 years and never had a problem with it. Easy to setup and easy for the operators. Hope that helps...
Electronics Forum | Wed Sep 08 11:02:36 EDT 2010 | kjs123p
My company is going to be moving into a new building and at that time, I would like there to be ESD flooring installed. What types are available, and what are the pros and cons of each?
Electronics Forum | Fri Sep 10 16:22:06 EDT 2010 | jamike
Hi I am currently having problems with micro bgas not self correcting in the reflow process, what could cause this?
Electronics Forum | Fri Sep 10 17:18:10 EDT 2010 | spitkis2
They may be misaligned so much so that self centering would not occur. How are you placing the micro BGA's? Depending on how the boards are transported onto the oven's conveyer, by the time they start to go through the oven, there could be additio
Electronics Forum | Thu Sep 16 18:25:22 EDT 2010 | slwolbert
Thanks for the response Travis. I'd think the table would inch or move if it were stuck inching keys. The table would eventually trigger one of the overtravel sensors on this ancient machine. Much Appreciated, Steve
Electronics Forum | Sun Sep 12 12:45:56 EDT 2010 | tony1
Hi there, does anyone experience in NiPdAu solderability dip & look test? I experiencing solder non wet issue on side I/O & also center ground for QFN package. Appreciate someone can offer me a solution. Thanks