Electronics Forum | Thu Mar 14 18:16:58 EDT 2013 | isd_jwendell
With those interlocks tested, and confirmed good. I would check the end-of-travel safety switches next. It may think that the head is at the end of it's travel.
Electronics Forum | Wed Mar 13 10:27:04 EDT 2013 | zinalnpatel
We currently own a MV-2HTLP and I was wondering if we can zoom out to check the component that are bigger in size than the view area of the machine at the default position. If it is then can someone please help me out with it.
Electronics Forum | Wed Mar 13 10:53:58 EDT 2013 | emeto
Patel, I don't think you can change the camera view as it is not moving, neither the board does. Emil
Electronics Forum | Wed Mar 13 13:05:03 EDT 2013 | zinalnpatel
Evtimov, Thanks for the information. In this case then if the component size is bigger than the view area how to I teach the part and will the machine inspect it?
Electronics Forum | Tue Apr 09 12:08:25 EDT 2013 | zinalnpatel
I am new into the programming of mirtec MV2-HT and I have tried a lot of things tyo program for the IC bridge inspector but it fails everytime, Can someone please help me learn the programming of IC bridge. Thank you
Electronics Forum | Thu Mar 14 10:22:49 EDT 2013 | mmauser
I'm looking for a manual for a branson untrasonic welder made by emerson. actuator 921AES manual #100-214-166 and welder unites 900MA manual #100-214-177. Where can I get these?
Electronics Forum | Mon Mar 18 10:33:27 EDT 2013 | babe7362000
It is not the feeders having the issue. The tape on the strip of parts does not want to pull up easily. I just wondered if anyone else out there is having the same issue. Thanks for any feedback.
Electronics Forum | Wed Mar 20 18:11:10 EDT 2013 | garym4569
Is the problem with the same component or manufacturer? Just for kicks, load a different component on the same feeder. Run machine in trial mode and place only that component on double sided tape. Gary
Electronics Forum | Wed Mar 20 07:16:03 EDT 2013 | vinitverma
I have customers populating LEDs on flex PCBs (with Aluminum support plates) with sizes up to 1,200mm (say 4ft) even on old Philips/Assembleon Topaz machines. What components are you planning to assemble on your flex PCBs?
Electronics Forum | Thu Mar 21 13:23:15 EDT 2013 | cyber_wolf
Stay away from used Nitrogen ovens unless you have a specific need for it. The flux management is a pain in the arse to clean. I don't care how simple they claim it is.