Electronics Forum | Tue Jul 15 15:39:24 EDT 2014 | ahernand75
Hello, I'm looking to buy PCB magazine for my SMT process and would like to have feedback about Nikko products. Any comment about them is welcome and thanks in advance for your support.
Electronics Forum | Wed Aug 13 03:49:14 EDT 2014 | stgpcba
We can't provide you pcb magazine,but only PCBs if you interested. www.China-pcbassembly.com
Electronics Forum | Wed Jul 16 03:54:01 EDT 2014 | enfrafer
how much time in average do you spend in set up time? how much % of productive time do you waste in setup? what smd equipment do you have?
Electronics Forum | Wed Jul 16 08:07:13 EDT 2014 | emeto
I have seen it all. from OEM that has 12 assemblies and the setup is always on the machine to a 5-6 setups a day in a CM environment with small quantities.
Electronics Forum | Fri Jul 18 11:31:31 EDT 2014 | jagriffin
Thanks Mac! I have been doing a lot of reading and I think I understand me challenge ahead of me. I do however have a double sided assembly and the BGA's are on the second side. So I know I have to make this a quick build…. June
Electronics Forum | Wed Jul 16 19:38:28 EDT 2014 | garym4569
What is the base cost of an inline pcb etcher? Specs: fiducial alignment, smema interface, 400mm x 400mm marking area. Will be used to mark panel 2d codes, pcb array 2d codes, and human readable. Thanks Gm
Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Sun Jul 20 14:55:25 EDT 2014 | bobpan
Typically when this happens the lighting in your package for a part in one of those cycles has 0 0 0 in the 3 light settings. You need to check all your package types that are used in your program and makes sure they are adjusted correctly. Good Luc
Electronics Forum | Sun Sep 21 15:35:42 EDT 2014 | gascon5383
not sure what the older type is. i have the manuals for topaz xii version. im assuming thats newer than what your looking for but let me know.
Electronics Forum | Fri Jul 25 09:54:00 EDT 2014 | emeto
Hello all, what is your opinion on step stencils. Is it better to have the step on the squeegee side or on the bottom side of the stencil? Why you do it this way? What are the advantages and disadvantages?