Electronics Forum | Thu Aug 11 22:38:22 EDT 2016 | anhsang38
Dear Davef Thanks for your information. I already have measured it at the same position for 2 kind of component but the result does not change. Pls help me...
Electronics Forum | Fri Aug 12 08:52:29 EDT 2016 | sarason
In short physics. A large Black object will absorb more energy than a smaller non-black object. Thus the temperature will remain lower around the black object as it heats up ! sarason
Electronics Forum | Tue Aug 16 08:29:32 EDT 2016 | hotran
Can Mirtec AOI detect MISSING metallization on the resistors? I love to know how to add into the program to catch it. Thank you!
Electronics Forum | Mon Aug 22 11:25:20 EDT 2016 | hotran
Thank you very much ! You right I will increase the acceptance up to 75% but create more false call. Thank you all.
Electronics Forum | Wed Aug 17 17:17:45 EDT 2016 | davef
Warpage of a completed assembly is an uncommon requirement. I would ask whoever is laying that requirement on you to define how they would like you to measure it.
Electronics Forum | Thu Aug 18 06:06:07 EDT 2016 | technotronix
Here is a PCBA Warpage calculate method after complete SMT/Through hole assembly Warpage calculation method = warping height / length of the curved edge
Electronics Forum | Fri Sep 09 05:32:11 EDT 2016 | jasltd
Are your solder relief pads connected to anything in terms of ground planes that would increase the thermal load or are they floating copper? I take it your talking about wave solder relief pads?
Electronics Forum | Mon Aug 22 18:25:54 EDT 2016 | cox1
I have a MS level 3 component that has been on the shelf for 7 years. Should it be baked before usage. The HIC card reads ok- and it was stored with desiccant. History of the part is unknown, was purchased from franchised distribution.
Electronics Forum | Fri Sep 09 05:29:25 EDT 2016 | jasltd
simpel answer is yes it will need to be baked, the typical shelf life for a sealed component assuming it has been sealed would be a max of 2 years but some are shorter. The bugger problem with the device may well be solderability of the device!
Electronics Forum | Wed Aug 31 07:40:58 EDT 2016 | bukas
BIOS stopped loading, now when I start machine monitor doesn't receive any signal. tried to start machine with different hard drive but nothing