Electronics Forum | Fri Feb 15 13:45:18 EST 2013 | cowens
We have a MPM UP2000. We are getting a hardware limit error when we turn the machine on and try to reset. The F14 fuse blows every time we replace it. The downstop is the first axis that it tries to go through but we get this error. Any help would be
Electronics Forum | Tue Feb 26 07:46:04 EST 2013 | stephendo
If anyone still disagrees with you point, out that the "of each" refers to individual pads. If the 95% refered to 95% of the pads it would not have said "of each". Also someone correct me if I'm wrong but isn't this standard to do with solderabilit
Electronics Forum | Tue Feb 19 18:51:45 EST 2013 | tombstonesmt
We've had great success with acrylic based cut with xylene. Very accurate with little to no masking necessary for keepout areas, very rarely have to make adjustments on our Asymtek. On the other hand we have an Asymtek dedicated for silicone coatin
Electronics Forum | Sat Feb 23 14:49:11 EST 2013 | duso02
Too bad you couldn't make it to the APEX show. Lots of equipment, and coating experts on hand. To answer your questions: 1. Yes, multiple brands, as well as non-UV cure. 2. Yes, there are. What you choose really depends on a lot of other info. 3. Ye
Electronics Forum | Wed Feb 20 10:26:56 EST 2013 | wbailey
I am getting a lot of false calls on our AOI(YTV F1)on low contrast part markings like brown-on-yellow tantalum capacitors and etched oscillators, and on lead banks where the pcb has the part outlined in silkscreen. We are contract and cannot change
Electronics Forum | Mon Mar 25 20:02:05 EDT 2013 | hegemon
Thats a good one Dave. Sorry to say, but I have seen setups very similar for the mass repair of Playstations. Just add a heat gun over the top and you are ready for some rework! . And just LOOK at the controller! With E-Z turn knurled knob for setti
Electronics Forum | Thu Feb 21 12:02:03 EST 2013 | pbarton
We agree with all of what Patrick has said. Hopefully your equipment is capable of the ideal setup you describe with no back flow until the product hits the wave and then back flow until the product emerges the other side. One other reason to strive
Electronics Forum | Thu Feb 21 11:22:06 EST 2013 | emeto
It is a very interesting thought. However, teach all positions on the PCB might be challenging if you don't have them in the file. I think it is a smart think for OEMs as they would have all the resources to control their files. For CEM I don't see i
Electronics Forum | Thu Feb 21 14:34:29 EST 2013 | danburnikel
I have a product that is ramping up to volumes higher that our batch oven can handle. One option is to apply Loctite E-30CL on to our circuit card and send it through a heller 8 zone oven. Was thinking of a oven temperture of 150C for about 10 minu
Electronics Forum | Fri Feb 22 13:48:27 EST 2013 | cyber_wolf
I have been told that stencil nano-coatings are rain-x in a different container. I guess I half believed it until I opened up a sample the other day. It smells EXCACTLY like rain-x. For those of you that have never smelled rain-x it has a very distin
