Electronics Forum | Tue May 05 11:12:01 EDT 2015 | anirudh_thabjul
Thankyou once again dude. Please Don't mind it. I have one more doubt regarding the Max.Power Rating of SMD Resistor. ---"Is same principle which you told application for Maximum Power rating Of SMD Resistor also"?--- i.e Higher Powerrating is
Electronics Forum | Sat May 09 09:10:19 EDT 2015 | sarason
Might I add, avoid Y5V if you want a reliable design and Marc is correct do look at those charts for X7R voltage dip under load, if you are doing low volume, save yourself the trouble and time, just overrate. sarason
Electronics Forum | Sat May 09 09:12:53 EDT 2015 | sarason
Might I add, avoid Y5V if you want a reliable design and Marc is correct do look at those charts for X7R voltage dip under load, if you are doing low volume, save yourself the trouble and time, just overrate. sarason
Electronics Forum | Thu May 21 01:52:45 EDT 2015 | aemery
The AP-HIE came with paper manuals. I need to keep my paper manuals and don't have an extra, but the last model of the AP, the AP-Excel, came with manuals in PDF. I could burn a CD and send it to you. The machine use and operation is almost identi
Electronics Forum | Thu May 28 09:39:19 EDT 2015 | emeto
Good luck Alexandru. I went through this years ago and it is a lot of fun. For the next 5-6 years you will learn a lot about P&P systems, as you will get your feedback from your customers(trust me it is going to be a lot and you will have to modify
Electronics Forum | Tue May 05 21:38:40 EDT 2015 | kahrpr
Get an accurate scale. You can rent them if you do not have one or do not want to buy one. Weigh the bare board then paste the board and re-weigh it. Subtract the 2 and you have the weight. solder paste is sold buy weight so then you can calculate th
Electronics Forum | Thu May 07 02:16:45 EDT 2015 | buckcho
i need a menthod for calculating amount of > solder paste need in a single pcb or a lot of > pcb(1000 pcb). i need reduce wastage of solder > paste in the process , so any one can > help........ Hello, you can measure the weight, before the pas
Electronics Forum | Tue May 05 21:17:46 EDT 2015 | warwolf
So, im tasked to outline that the centre of a 28cm x 20cm PCB has the most susceptible stresses in the centre, my reson is to avoid putting the BGA there. I had a really good article outlining this but I carnt find it. can anyone help?
Electronics Forum | Wed May 13 10:34:57 EDT 2015 | squeekypigeon
If memory serves me right, if you are test picking a component which will be served to the machine via an LCS the 'pick position' will automatically set itself to feeder slot 1. If you change this to something more central (I used to use location 4
Electronics Forum | Fri May 15 21:07:35 EDT 2015 | jlawson
I think Valor MSS is best in market solution, ODB++ no issue and has documentation, coupled if can afford VPL part packages offers very accurate images of PCB in docs Siemens UnifcamFX is not bad but dated in functionality scope. Valor MSS Process P
