Electronics Forum | Wed Dec 17 07:43:44 EST 2008 | muarty
I have just carried out an evaluation project including Mirtec, MVP, Landrex and Viscom. If you are interested in my findings you can contact me offline. In short though, we found that each had plus points to them. If you could join together the outs
Electronics Forum | Tue Dec 16 07:03:14 EST 2008 | buckeyes903
Hello everyone, I am new to the site, and I am hoping someone here can help me. We have a Manncorp MC386 and wanted to add a dual monitor video card to it. IT has an avalible PCI slot, so we bought a video card that will support dual monitors and
Electronics Forum | Wed Dec 17 09:17:53 EST 2008 | caldon
Hi Matt, Please help us understand what you are trying to do with the dual monitors. If my memory serves me correctly the PC on the P-N-P is mostly used as data storage. The vision system including component cameras, fiducial cameras and bottom visio
Electronics Forum | Wed Dec 17 12:04:44 EST 2008 | buckeyes903
Well my boss has explained to me that when he imports the data, because it is not the correct file we have to switch it over to the correct style and doing that on the PNP is easier. I have not seen anyone do this since I have just started a few mon
Electronics Forum | Tue Dec 16 10:59:50 EST 2008 | patrickbruneel
Here's a new ban proposal by the EU on the flame retardant deca-BDE. A product that has kept our electronics safe for over decades. The good part is that the scientific community in the EU looks like to put up a bigger resistance as was the case wit
Electronics Forum | Wed Dec 17 04:22:10 EST 2008 | bing007
The supervisor password is set and the current password is not known. I need to reset this. Is there a top level password above the supervisor level that can be input to enable me to access the machine data without clearing all the machine data out?
Electronics Forum | Wed Jan 07 02:08:56 EST 2009 | sachu_70
Hi! Just joined the circuit. Hot Bar soldering is very reliable provided the Flexible Printed Circuit (FPC) and Rigid PCB design support this technique. Some of the critical aspects that need to be considered include Stencil apperture design for sold
Electronics Forum | Mon Dec 22 11:09:21 EST 2008 | mfcat
We changed paste manufacturers rather recently and are now seeing SOT23s falling off after wave solder. These parts have a dual process... we stencil print paste, apply glue, populate then reflow. Only SOT23s fall off, chips are fine. We do not be
Electronics Forum | Mon Dec 22 12:06:27 EST 2008 | evtimov
Hi, it seems like a glue problem to me. If you don't have enough glue on SOT23, you have no contact and the part is holded only by the paste, which results bad in the waver machine. So first I would check is the glue amount under the SOT. The second
Electronics Forum | Mon Dec 22 14:52:18 EST 2008 | wrongway
We run our process like that all the time paste then glue we use same profile as if we were just reflowing paste once in a while we have A plastic bodied part that has that problem we asume it was some mold relase still on the part basicly comtamena