Electronics Forum | Fri May 20 10:09:02 EDT 2016 | ttheis
Unless your products are rather simple or throughput is not a major concern, you are going to have a hard time finding all of that equipment on that budget without considering used equipment. A low-end pick and place machine will consume that entire
Electronics Forum | Thu Jun 02 09:33:50 EDT 2016 | emeto
Hi, if I were you, I would probably go for testing and rework equipment. Adding manufacturing to your business, will most probably exceed your preliminary expectations. Manufacturing is much more complicated than you probably think. I have used manu
Electronics Forum | Thu Jun 02 10:28:34 EDT 2016 | mnorthey
I have a number of machines sitting in the back room that I have been trying to sell. 8 Siemens (4 S15's and 4 F3's). A good start if you are interested; I also have an older Omniflo7 Oven as well as an old printer if your interested. All are older b
Electronics Forum | Fri Jun 03 09:11:02 EDT 2016 | sumote
I had this long post typed up and then I re-read your post. No used equipment? Like others have said, your budget could could easily be swallowed up by 1 piece of equipment. I would work with your Program Manager at your "assembly partner". You nee
Electronics Forum | Thu Jun 02 08:33:42 EDT 2016 | emeto
I usually get a excel or word file from my stencil house with all the data you need. It give you aperture sizes, volume and Aspect Area ratio... DCode Shape X-Size Y-Size Pitch Volume Area Ratio Aspect Ratio Qty D1
Electronics Forum | Wed Feb 08 01:30:02 EST 2017 | nikkilouie
Im having trouble with and Ekra x5 machine. It > works fine when up being run constantly, but if > it sits for 10-15 minutes when you try to move > the Y table to the front of the machine it makes > a loud sound as if the table is hitting/catchin
Electronics Forum | Thu May 26 14:06:03 EDT 2016 | stevedc
I did clean both lenses from the outside and checked all the MOD codes. I even removed the battery to reset everything and re-programmed all the codes but to no avail. I will strip it down and fully clean it to see if that helps. Just strange that
Electronics Forum | Fri May 27 00:18:15 EDT 2016 | stevedc
Soooo.... I started to take the laser off last night to clean it and decided to put it back on to do some more measurements to see if anything obvious turned up and lo and behold it is not good !!! Most likely cause I can think is that you were righ
Electronics Forum | Tue May 31 11:35:12 EDT 2016 | swag
It's a Spectrum Technologies Sienna 300 Series. The main down fall is that you can only program x and y (as far as I know). By that I mean you can't do circles or diagonals. Only squares and rectangles or shapes with only vertical and horizontal s
Electronics Forum | Tue May 31 01:52:39 EDT 2016 | rstsg
Hi experts, I am new to board design, and have some question please guide me, I have a hardware design Idea, which needed 2 connect a sensor with an MCU, so i have 2 PCBs (both evm) 1:- How should i start to make a single PCB using both (removing few
