Electronics Forum | Mon Aug 08 16:14:36 EDT 2011 | wmburke
We are building a plasma diagnostic to monitor MHD phenomena in tokamak. As part of the development, we need high-voltage, high-power RF capacitors to tune and match an inductive load. This application is similar to a small induction heater, with t
Electronics Forum | Thu Aug 11 07:01:34 EDT 2011 | franxsmt
Thank you very much for your informative and helpful reply. I have a few more questions:) 1- So for the case 1: should I apply the glue to the PCB with the same method as I apply solder paste? (with screen printer and squeegee). If so, I would guess
Electronics Forum | Mon Aug 15 10:06:38 EDT 2011 | terrytaaffe
Hi All, > > We are thinking about adding a SPEA > 4040 flying probe tester to our facility to add > some flexability to our test capabilities. Does > anyone have experience they could share on these > units? I would be most interested in progr
Electronics Forum | Thu Aug 18 14:13:36 EDT 2011 | davef
Here are a few labs that would be good starting points: * Robisan Laboratory; 6502 East 21 St, Indianapolis, IN 46219; 317-353-6249 F357-1270 Susan Mansilla, Technical Director robisan1@aol.com * Trace Laboratories - East; 5 North Park Dr, Hunt Vall
Electronics Forum | Wed Aug 31 12:00:59 EDT 2011 | cpitarys
Vapor phase or vapor degreasing cleaning for electronics is simple technology that holds merit on process situations like you described. Easy and quick to set up and process with today's modern equipment you can be up and running in no time once the
Electronics Forum | Fri Sep 02 19:31:40 EDT 2011 | jlawson
I agree that if information is processed correctly up front in process down stream QA becomes less expensive ie AOI etc as AOI at end of lines is telling you you have made mistakes in up stream. I better to eliminate mistakes or have process to avoid
Electronics Forum | Tue Aug 23 16:48:29 EDT 2011 | jax
assuming Sn05Pb93.5Ag1.5 Without knowing what you are trying to solder, PTH or SMT, the time might not be that far off. Does that time include stripping, cleaning, plating the leads prior to soldering onto the board?... pre-tinning the board as well
Electronics Forum | Tue Sep 11 21:24:00 EDT 2012 | vergara1
I'm also looking for tips for SMT hand soldering > with Sn05Pb93.5Ag1.5. Our technician is quite > good with standard SMT hand soldering, but hasn't > worked with HMP solder. > > Some specific > questions: > > - If the iron tip is hot enough >
Electronics Forum | Wed Sep 07 00:47:53 EDT 2011 | woodsmt
PCB, What is telling you that you have cold solder? You do not give much info. My QA/QC love this term to describe a multiple of issues. They are usally very wrong. If this is a reflow process and it just affects one part? An SSOP is not likley t
Electronics Forum | Tue Sep 13 11:05:38 EDT 2011 | nucleartoast
I worked for Electrovert for 20 years as a machine designer. Our first computer controlled solder machine the Century 2000 used Infra red pyrometers that were very accurate - once you calibrated it against what you wanted to measure. So the aim and s