Electronics Forum: inductor problem (Page 1 of 5)

Renco Power inductor (RL-1608-S-330) - common failures??

Electronics Forum | Wed Jun 09 14:41:12 EDT 2010 | ronchap200027

Has anyone had issues with Renco inductors failing. The component I'm having problems with is a 330uH shielded power inductor. Out of 36 board failures, I have 17 that failed because this inductor failed. Most often they end up reading -1.34 uH.

coilcraft i ROHS inductors soldering problem

Electronics Forum | Sun Aug 10 03:41:20 EDT 2008 | eyalg

Thanks for your promt reply It was very usefull Eyal

coilcraft i ROHS inductors soldering problem

Electronics Forum | Fri Aug 08 09:49:17 EDT 2008 | scottp

We've seen the exact same problem. The solder joints had negative wetting angles and x-sections show that the PdAg termination dissolved into the solder. We no longer allow PdAg terminations.

coilcraft i ROHS inductors soldering problem

Electronics Forum | Sun Aug 10 03:39:21 EDT 2008 | eyalg

Thanks Pete yes we usu ROHS solder paste in our process. I agree that this termination is more suitable for adhsive bonding rather than soldering. We'll try changing the termination type as you recommended. Eyal G

coilcraft i ROHS inductors soldering problem

Electronics Forum | Thu Aug 07 10:02:10 EDT 2008 | eyalg

We are facing low quality due to soldering opens with coilcraft inductors 0402CS-2N7XGLW. The termination used is(suffix L =RoHS compliant silver-palladium-platinum-glass frit. Did anyone had this problem in the past? Can we do better using T = RoH

coilcraft i ROHS inductors soldering problem

Electronics Forum | Thu Aug 07 11:58:36 EDT 2008 | pbarton

We have experienced the same problem with Pd/AG and P/Ag terminations on precision resistive parts. The problem is dissolution of the termination metallisation into the bulk solder. This is exacerbated by the higher thermal profiles required for RoHS

waterwash of inductors

Electronics Forum | Fri Nov 19 16:53:48 EST 2004 | grayman

Hi, We used to clean 20 pieces SMT inductors before but no problem with this process. Please confirm what type of inductors is it SMT or hole type. What type of chemical and machine you are currently using? Maybe I can help you out.

Green inductors

Electronics Forum | Thu Feb 16 12:07:19 EST 2006 | dpmilk

We have been using Coilcraft 1008CS inductors for several years. We have had problems with them turning green when we use lead-free solder paste. We have tried several solder pastes (water soluble and no-clean)from different manufacturers, but the

Component Skew during Reflow Process

Electronics Forum | Thu Aug 01 13:15:52 EDT 2019 | davef

if the inductors were your only problem. My mom wouldn't be pleased with the V30200C dual voltage rectifier just below the inductors

Coilcraft Inductors Open

Electronics Forum | Wed Aug 13 19:57:05 EDT 2014 | suroy

After wash cycle, some of the inductors are open (broken wire). Resistance across the two ends should be below 4 ohms (normal) however on broken wire shows above 200 ohms. I am wondering if anyone else has seen this problem. We are using High-Reliabi

  1 2 3 4 5 Next

inductor problem searches for Companies, Equipment, Machines, Suppliers & Information

High Throughput Reflow Oven

ONLINE IPC Training & Certification


Best Reflow Oven