Electronics Forum | Thu Jun 05 17:54:42 EDT 2008 | iantech
The the HDD onwindows 2000 pc running Fuji Flexa > for 5 m/c's on our smt assembly line died 2 weeks > ago. We've since reinstalled a new HDD. To cut > along story short Fuji via their agent here > (Productivity Partners Formerly Astro) after
Electronics Forum | Thu Jul 03 09:30:49 EDT 2008 | wavemasterlarry
Listen I noticed that my names being mentioned in a thread thats related to wave soldering. Im glad that I can attract the attention of a recruiter on a nation wide forum. As some of you know I boycotted this site due to censorship from the meditator
Electronics Forum | Tue Sep 16 10:15:48 EDT 2008 | mw_fl
Would appreciate any input you might have in our search for an SMT line. We are an OEM done our through in house but outsourced our SMT production. We have a couple of new products that are going to be higher volume so we have decided to look into ad
Electronics Forum | Fri Oct 31 12:50:12 EDT 2008 | devgru
Dominik, I have to agree with Andrew on his choice of Inspection Technology, but not the vendor. I looked at 2 of the 3 that you are asking about (TRI did not make my cut as I just didn't get a good feeling from them). I also looked at the Mirtec and
Electronics Forum | Wed May 06 08:15:39 EDT 2009 | xinxi
Hi all, I understand that this forum is more to surface mount discussion. But I am eager in sorting out the spray fluxer problem. Please provide me with any ideas that you think might cause it. I have a problem in starting up/initialising the wave
Electronics Forum | Mon Sep 21 20:45:55 EDT 2009 | davef
10.4. Pre-Cure Examination. Immediately after material application, the uncured conformal coating shall be examined for: a. Bubbles and Air Entrapments. These defects shall be broken by vacuum, with a sharp probe, or other appropriate tools. b. Bridg
Electronics Forum | Thu Feb 18 14:42:38 EST 2010 | djsmith1000
Hi everyone, First post here. I am completely new to smt as well. We are a small startup and would like improve our in-house smt assembly capability from manual assembly. We are looking at small production runs, initially about a total of 200 board
Electronics Forum | Mon Mar 07 11:54:46 EST 2011 | rway
Now I have a clearer picture of your operation. It seems your company does not want to incur the cost of board redesign, and I thought it was the initial investment of the capital equipment that had them scared. You stated, "Unfortunately I can't g
Electronics Forum | Mon May 09 16:44:33 EDT 2011 | dcell_1t
Hi, We have been struggling with an issue of non wetting on a QFP (Renesas - 256, Sn90Pb10) but the issue "desapears" sometimes for a while and then back again suddenly. This is the scenario: Component: QFP 256 / Renesas / Sn90Pb10 / 0.5 mm pitch S
Electronics Forum | Tue Aug 30 11:13:23 EDT 2011 | markaustin
Hello Bill A colleague here at ACW just told me about your question and as we have a few of these machines I feel that I'm in a position to answer you. Prior to 2007 we only used DEK265 (GS & GSX) machines and these we getting a bit old and passed