Electronics Forum | Fri Aug 09 03:59:35 EDT 2019 | sssamw
Did you check the pin location accuracy before placement? I mean if possible pin was hit or misaligned a little before placement, so the pin cannot inserted in hole then bent. And maybe you need contact your component supplier to study together.
Electronics Forum | Wed Nov 20 21:30:36 EST 2019 | sssamw
first of all, you need check the strain caused by interference during connector insertion. If must done by SMT, then a claw would be better than nozzle.
Electronics Forum | Sun Nov 24 12:44:10 EST 2019 | bane016
I have problem with feeder cart.I have no voltage on any of the 17 feeder connectors, and when i insert the cart in the machine i get the message that the cart is not connected. I have a voltage to one separate connector normally.
Electronics Forum | Fri Sep 18 18:20:45 EDT 2020 | dwl
Count on Tools makes hard foam support block with magnetic bases that work really well. check with them to see if they make them for the SPV. Insert standard: I receive no benefit nor compensation from the aforementioned company.
Electronics Forum | Mon Nov 30 17:46:17 EST 2020 | charliedci
Asking for recommendations on tape and reel service provider. Have many bulk TH components, we're looking to machine insert. Appreciate any input. Charlie
Electronics Forum | Tue Oct 19 19:29:03 EDT 2021 | compit
What is this software? Do you have a LAN card inserted into the machine? I thought about adding a LAN card and LANTASTIC software (old, under DOS) but maybe you have a better idea?
Electronics Forum | Wed Oct 27 11:50:36 EDT 2021 | proceng1
I'm not clear on your current process. You run FIRST SIDE. Then paste and build SECOND SIDE. Then you insert a header from the FIRST SIDE so the pins solder with paste on the SECOND side. And you run the board with the unsoldered header on the bot
Electronics Forum | Thu Dec 02 21:11:59 EST 2021 | dwl
We used to use Titanium inserts when there wasn't much clearance between SMD and thru-hole leads. I don't recall how tight we could get though.
Electronics Forum | Fri Dec 03 11:52:29 EST 2021 | dontfeedphils
The opening in the wave pallet for the TH connection in question would be a titanium insert rather than just a cutout in the durastone like normal. They're able to hold tighter tolerances with the titanium vs durastone as far as I understand.
Electronics Forum | Wed Jan 04 03:08:12 EST 2023 | msirifat
Hello Stephen, thanks for the advice. We are producing LED TVs & we have a facility for SMT and manual insertion. We are also thinking of changing the board finish from OSP (due to its shorter shelf life) to ENIG/Immersion Tin.