Electronics Forum | Mon Aug 08 14:28:18 EDT 2022 | davef
While IPC-A-610 [ https://www.ipc.org/TOC/IPC-A-610G.pdf ] is a good starting point for establishing your inspection requirements, there is no requirement for using a specific tool to make a measurement. You need to choose the microscope, AOI, loop,
Electronics Forum | Wed Oct 06 15:29:24 EDT 1999 | Tony
| Our first article inspection after machine placement can take several hours depending on the complexity of the board. The operator visually checks the board against the drawing and bill of material. I'd be interested to hear if there are any other
Electronics Forum | Fri Jul 23 12:38:33 EDT 1999 | Earl Moon
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Thu Jun 06 02:15:05 EDT 2002 | Sam
Hi. I'm checkin up needs for AOI or AXI in our SMT lines, and advantages and weak points between AOI and AXI (=automatical x-ray inspection). Our case is high mix low volume production 24h in 5 days of a week, so there are no online time to spend pr
Electronics Forum | Thu May 26 06:59:06 EDT 2005 | CLampron
Good Morning, We have several Mirtec table top machines. We bought the first one when it was under the Samsung name. We had the advantage of doing a side by side comparison with several other systems. The Mirtec was the leader in performance. Since
Electronics Forum | Fri Dec 28 17:44:41 EST 2007 | flipit
Back in the mid 90s I used an SVS 3D solder paste inspection system. We used it as a stand along unit but it was an inline model. We would bring printed PCBs off the Dek 265 solder printers and check every 5 or 10 printed panels. They almost alway
Electronics Forum | Fri Oct 29 11:59:35 EDT 2010 | rway
We currently have two YTV-M1 inline-systems from YesTech. I have been using them for around 3 years now. They are descent machines. If you decide to go with YesTech, go for the F1 system. This will give you the ability to upgrade with side camera
Electronics Forum | Fri Feb 11 13:02:01 EST 2011 | deanm
Thank you for all who read this with interest and especially those who replied. I have considered the points posted and here is what we came up with: We all agree that double inspection is a wasteful operation especially if the operator is more crit
Electronics Forum | Thu Feb 28 10:22:46 EST 2013 | rway
If your silkscreen is too close to the toes of your leads, you can bring the lead bank inspection box in a little bit to compensate. I haven't had many issues with tantalum caps. I inspect those under white light with no filter just fine, but then
Electronics Forum | Wed Sep 20 09:24:09 EDT 2017 | bstogsdill
Hi- I am attempting to determine if the "User Performance Inspections" on table 4-1 are required or are they just optional? Section 4 para 4.2 only refers to Qualification Inspection and Quality Conformance Inspections that are performed by the past
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830