Electronics Forum | Mon Jul 25 23:05:40 EDT 2022 | kamedatec
I did something similar on Neoden machines. VisualPlace software helps a lot with this task, but the coordinates are never in the correct area where the PCB is, so I manually check the position of the first component and my software adjusts the posit
Electronics Forum | Thu Sep 08 18:10:09 EDT 2022 | mt396596
We just went through a similar issue with our MY12E. Make sure your Midas vacuum system is working, check your Midas Z friction. Also verify the Centering unit centering band. You can swap your MOTZ and MOTC to rule out the card. The tool install t
Electronics Forum | Thu Oct 20 16:11:08 EDT 2022 | cyber_wolf
I have no experience with the MY100. Personally, I'm not a fan of platforms where the PCB is not stationary. Mechanical feeders typically require more maintenance than electronic. Yamaha is one of the few I haven't worked with. It is my understan
Electronics Forum | Wed Nov 16 17:18:42 EST 2022 | emeto
Volumes are not the only factor here. You might have low mix and low volume, but high complexity. Machine you pick based on the most challenging components you have to print/place/reflow. If boards are simple, than your level of expertise is importan
Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm
Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default
Electronics Forum | Mon Feb 06 18:45:26 EST 2023 | nitroone
Hi guys, So i am trying to find out what type of air quality sensor you use in your facility if any? What other sensors are required to be installed to ensure that air quality is safe for workers? We have both an inline oven, and a selective solde
Electronics Forum | Fri Feb 17 19:48:01 EST 2023 | SMTA-64387083
15K sqft sounds like a good size facility, you should have someone that knows or learns about ESD and owns it. Check Out esd . org, ipc . org, smta . org for standards & info. Tile vs Epoxy = Tile's better but much higher initial cost. Pay attention
Electronics Forum | Mon Nov 17 14:02:33 EST 2003 | Mark Peo
As you have seen, the 1088 doesn't need much in the way of P.M. We recommend: --Monthly vacuuming in the base and under the hood (ie Dust Bunny control) --Lubricate Edge Hold Conveyor Chain and leadscrew (if the Edge Hold Conveyor option is installe
Electronics Forum | Wed May 03 13:35:00 EDT 2023 | ttheis
Thanks, Deni! We're replacing two 4-spindle GSM's with two GX-11S with Flex3 front and IL4 in the rear. These we plan to use a mix of our pneumatic & 24V feeders as well as high speed feeders as we acquire them. The sellers advised that the 24V kits
Electronics Forum | Thu Jun 01 12:54:33 EDT 2023 | tommy_magyar
I am using 2x SP710, one is 5 years old, the other one is one year old. The old one never had an issue, the new one had a camera problem when it was installed, but it was changed under warranty - no problem ever since. Very easy to use. I only ever