Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Apr 11 08:41:44 EDT 2017 | jdengler
Do you have an interlock bypass key? If you do can you reset the interlock in bypass? If you cannot, I believe there is a pico fuse on the interlock pcb in the control panel that may have blown.
Electronics Forum | Wed Apr 30 18:57:05 EDT 2008 | fastek
That's pretty funny.............change the cognex card. Jim you indeed have an interlock problem an if this is a UP-3000 which I suspect it is there are several interlocks if I recall correctly.
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Thu Apr 10 12:22:44 EDT 2008 | stepheniii
And I don't think you are talking about lockout keys. I think you are talking about the safety interlock bypass keys. Pretty much the opposite of a lockout device. A lockout prevents the machine from being turned on and a interlock bypass allows th