Electronics Forum | Sun Nov 06 09:02:31 EST 2005 | davef
IPC-A-600 - Acceptability of Printed Boards
Electronics Forum | Sat Nov 18 21:20:58 EST 2006 | Fer
Dave, May I ask where did you find the 1.5%, or the goal of .005" (or .007") per inch? The IPC-A-600 bow and twist standard calls for a .75% based on the calculation of the test method TM-650, method 2.4.22, which calculates the percentage based on
Electronics Forum | Mon Apr 28 15:20:50 EDT 2014 | davef
Your customer is correct. Your supplier has clamped some sort of machine to your butt and has plugged it in the wall outlet. Honest mistake: * IPC-A-600H, 3.3.2 Lifted Lands - (Cross Sections) ... pertains to boards that were cross sectioned after t
Electronics Forum | Wed Jul 05 20:50:42 EDT 2000 | Dave F
Hey KC roll-up IPC-A-600 and smack those bums on the nose with it and say "Bad fabricator don't do that on the floor again" in a firm voice.
Electronics Forum | Thu Jul 06 09:26:21 EDT 2000 | K. Chak
Hi Dave, Thanks for the reply. Which part/page of IPC-A-600 Rev F. does it call for? ..may be I am not looking in the right spot. Thanks again. Regards Kc.
Electronics Forum | Thu Jul 06 09:26:24 EDT 2000 | K. Chak
Hi Dave, Thanks for the reply. Which part/page of IPC-A-600 Rev F. does it call for? ..may be I am not looking in the right spot. Thanks again. Regards Kc.
Electronics Forum | Tue Jul 22 03:56:24 EDT 2003 | A.G.
Are there existing acceptability dedicated criteria for ALIVH bare boards? (Equivalent to IPC-A-600) In particular, how can we assess copper foil cracking after thermal stress?
Electronics Forum | Sat Nov 18 08:42:11 EST 2006 | davef
Bow & twist: IPC-A-600. Acceptability of Printed Boards 1.5%; Goal 0.005" per inch; Practicle 0.007" per inch
Electronics Forum | Fri Jul 06 10:18:02 EDT 2007 | blnorman
According to IPC-A-600, measling can occur in epoxy-glass boards when the moisture content of the board is above 0.3wgt%. Is this the industy acceptance standard for max moisture content of a board?