Electronics Forum | Wed Jul 19 20:30:38 EDT 2000 | Dave F
Lennart: I think most laminators offer a halide free laminate. Two are Isola and Mica-Micanite. Contact the IPC Halogen-Free Materials Task Group
Electronics Forum | Tue Jul 11 11:36:00 EDT 2000 | Jacqueline
Hi folks, Does anyone have any recommendations and suggestions as to where I could find specific information such as websites, articles or books relating to DFM/ DFT (excluding ref. to IPC etc.) Thanks in advance Jack
Electronics Forum | Tue Jul 11 10:40:10 EDT 2000 | John Thorup
Charles Have you tried the SMEMA (now part of IPC)web page (www.smema.org)? Interface Standard 1.2 is available in PDF. John Thorup
Electronics Forum | Wed Jul 05 20:50:42 EDT 2000 | Dave F
Hey KC roll-up IPC-A-600 and smack those bums on the nose with it and say "Bad fabricator don't do that on the floor again" in a firm voice.
Electronics Forum | Thu Jul 06 09:26:21 EDT 2000 | K. Chak
Hi Dave, Thanks for the reply. Which part/page of IPC-A-600 Rev F. does it call for? ..may be I am not looking in the right spot. Thanks again. Regards Kc.
Electronics Forum | Thu Jul 06 09:26:24 EDT 2000 | K. Chak
Hi Dave, Thanks for the reply. Which part/page of IPC-A-600 Rev F. does it call for? ..may be I am not looking in the right spot. Thanks again. Regards Kc.
Electronics Forum | Fri Jun 30 11:00:23 EDT 2000 | Chrys Shea
IPC publishes a great little book on component identification. It's $20 for members, $40, for non-members. You can get it right off their website.
Electronics Forum | Thu Jun 15 16:19:08 EDT 2000 | LeeAnne Wambolt
Raeto, IPC-SM-782 will give land sizes for both reflow and wave soldering. LW
Electronics Forum | Mon Apr 17 19:44:20 EDT 2000 | Dave F
Ashok: Well, your customer probably has a good reason for wanting you to send them boards without holes in the solder mask. What is their goal for the mask capabilities after you get do reworking the boards? * Cosmetic surface coat? * Performance t
Electronics Forum | Fri Apr 07 11:52:44 EDT 2000 | Ashok Dhawan
Can anyone suggest a cleaning solvent for removing silicon residue after K Tape has gone through 2 cycles of reflow soldering ? The solvent or cleaning method has to be compliant to IPC Standards - to be used for cleaning gold edge fingers - PCB asse
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100