Electronics Forum | Mon Apr 08 20:43:58 EDT 2002 | davef
Regardless of the design technology of the board, we use shop floor management software that: * Calculates the period that it takes to assemble a job. Obviously, we enter product-manufacturing information [ie, BOM, material receipt dates, process fl
Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Tue Feb 01 09:53:37 EST 2005 | Howard Sommerfeld
I also have a spreadsheet tool for comparative analysis using criterion weighted scoring. It can be used to analyze any decision, and helps groups reach consensus on why a particular alternative is the way to go. As final steps you can also consider
Electronics Forum | Tue Apr 09 21:40:26 EDT 2002 | ianchan
We are a local enterprise with limited resources, just like you described, so hope this experience sharing helps : we place a production Visual Mechanical Inspection (VMI) inspector at the end of each Reflow Oven area, complete with magnify scope 30
Electronics Forum | Fri Jan 28 12:18:32 EST 2005 | Chunks
Your best bet is to do a decision making matrix. Each company has so many different criteria�s it's hard to pick out which one might be important to yours. Simply pick out your top 5 paste manufactures. Next decide what your "Eliminators" are - th
Electronics Forum | Tue Aug 28 12:05:42 EDT 2001 | mparker
The advantage of DPMO is that the numbers used are PPM, (Part Per Million), rather than percentage. Percentage can distort, depending on volume. For instance, 100 units processed, 25 defects found = 75 percent yield. 4 units processed, 1 defect found
| 1 |
winsouce.jpg)
.gif)
