Electronics Forum | Thu Mar 23 22:20:51 EST 2000 | Dave F
Chris: I'm unsure about the kits you seek. Solderability of: * Components: J-STD-002, Dip And Look Method. Malcom Instruments makes a very nice tester. * Boards: IPC TM-650 2.4.12A Solderability, Edge Dip Method Good luck Dave F
Electronics Forum | Thu Feb 22 21:01:12 EST 2001 | davef
We don't do this, but if we had to and lacking better advice, for all components I�d dry pack according to J-STD-033, store in a low temperature and humidity controlled environment [maybe using some semicon fab inert storage cabinets], review the eff
Electronics Forum | Sat Mar 03 23:24:55 EST 2001 | CAL
We test Parts and Components to IPC J-std-002/003. We also use a wetting Balance tester to determine solderability. We also test with SERA. We use ROSA to electrochemically revert the components back to their original state. Need more info ... email
Electronics Forum | Thu May 31 10:40:30 EDT 2001 | davef
See, all those bad thoughts we had ... The guilt, how do we live with it? 3 Spec Fir Tree General Technical Specification 3a Design/Layout: IPC-2221 IPC-2222 3b PCB Fab: IPC-6011 IPC-6012 IPC-4101 IPC-A-600 3c PCB assembly: J-STD-001 IPC-A-6
Electronics Forum | Thu Sep 23 10:03:09 EDT 1999 | Wolfgang Busko
| | I need know the types, characteristic specials for temperature, general characteristics and all I need know about of manufacturer for BGA. | | | | I Hope than you send my information about this. | | | | | Try this Link http://mot-sp
Electronics Forum | Fri Apr 03 08:25:11 EST 1998 | Scott Cook
| Does anyone know what the military uses for water | soluable flux in their wave solder process: | - wave flux | - rework flux | - cored solder | and approval steps to go through to qualify it. | Any information is appreciated. Thank you. Sylvia
Electronics Forum | Tue Mar 24 09:48:15 EST 1998 | Steve Schrader
| Do you know if there is an IPC standard or industry standard | that addresses the proper process for handling MSD's in the production environment....? (rework etc.) | Not the receiving area. | Thanks so much, | Robin Arnold | PCB Development | Har
Electronics Forum | Tue Feb 24 18:21:52 EST 1998 | Graham Naisbitt
You should refer to the IPC-J-STD001B and IPC-TM-650, they will give you good recommendations. Also, we do new reliability test systems and if you can give me your address and e-mail, I will send you some more info. Regards, Graham Naisbitt | looking
Electronics Forum | Sat Sep 29 08:19:16 EDT 2001 | davef
The current version of ANSI/J-STD-001, "Requiremnts For Soldered Electrical & Electronis Assemblies" is C [3/00]. The following sources can help you: * IPC http://www.ipc.org * SMTA http://www.smta.org * Document Center http://www.document-center.c
Electronics Forum | Wed Nov 07 10:59:55 EST 2001 | paulburt
Hello all, I have been tasked with bringing my company up to spec with J-STD-033, yes lucky me! My question is this: While I was searching the Web for suitable suppliers of dry cabinets I came across a company advertising a humidity control system f