Electronics Forum: jmw (Page 1 of 3)

quad align init problem

Electronics Forum | Thu May 20 10:01:23 EDT 2010 | jmw

Just a slight correction....the quad align card is located at the back rear right of the machine (in a cage). If it is a cyber-optics 4c machine....the laser align card is in the front card rack to the far left.

Fiducial Recognition

Electronics Forum | Wed Aug 18 08:54:07 EDT 2010 | jmw

Pads typically have paste on them. Unless you have some parts that arnt placed and you can wipe off the paste or tape off the holes in the stencil. Not a good option.

Army Works to Decrease Lead-Free Electronic Components

Electronics Forum | Thu Oct 07 10:40:06 EDT 2010 | jmw

Good Article......makes you wonder about all those components ending up in airplanes.......hmmmmmm

Quad 2c - QA Error #0?

Electronics Forum | Mon Nov 29 16:28:24 EST 2010 | jmw

If i remember this correctly....and its been years.......check to see what your theta number is for the pickup or placement. The number has to be 1 of 4 values.

quad qsp-2

Electronics Forum | Tue Nov 30 06:33:44 EST 2010 | jmw

If you are using the upward camera then you probably have to put in a placement offset for each head. This only effects upward camera placements...not quadalign. This is located in: 1. machine-calibration-camera lens 2. Choose upward camera2 under "

samsung cp30

Electronics Forum | Mon Jan 03 05:34:16 EST 2011 | jmw

Check in you system configuration that you dont have the opiton to use a matrix tray handler turned on. This is what i have seen cause this problem.

Quad IV C Recommendations

Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw

0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par

Quad IV C Recommendations

Electronics Forum | Wed Jan 12 07:22:02 EST 2011 | jmw

To add the camera to the machine would have a lot involved......including possible software/firmware upgrade. I would say buy a machine that already has it on it. To find the parts and upgrade it would probably cost more than the machine is worth. Ho

Quad 4c autoprogram

Electronics Forum | Wed Jan 12 07:25:08 EST 2011 | jmw

Leave your contact information and this evening i will e-mail you the zipped disks.

Quad 4c autoprogram

Electronics Forum | Wed Jan 12 11:56:38 EST 2011 | jmw

It will work on 95 if you can find copies.....cant remember if i ever had it working on 98. There is a mkcompat file in 95 that has to have settings adjusted to make it work for 95.......dont know if i have that info anymore. Will send you the disks

  1 2 3 Next

jmw searches for Companies, Equipment, Machines, Suppliers & Information

JMW Enterprises, Inc.
JMW Enterprises, Inc.

Buyer, Seller, Broker of Electronic Assembly Equipment

Equipment Dealer / Broker

309 West Pickle Alley
Rushford, MN USA

Phone: 507-864-7477

Benchtop Fluid Dispenser

ONLINE IPC Training & Certification
ZESTRON Analytical & Support Services

MSD Dry Cabinets
Software for SMT

Have you found a solution to REDUCE DISPENSE REWORK? Your answer is here.
Cable Assembly and Wire Harness Manufacturing Flux Connectivity

Low-cost, self-paced, online training on electronics manufacturing fundamentals