Electronics Forum | Thu May 05 07:58:35 EDT 2016 | cyber_wolf
Not sure what you mean. 0201's and 0402's are both on 8mm feeders. Juki's will do simultaneous picks an all 8mm feeders no matter the component size. Your feeders need to be maintenanced and calibrated to reliably pick 0402's and 0201's. I hav
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Fri Apr 30 10:42:40 EDT 2021 | oxygensmd
I have a customer who ask close to prototyping jobs with low volume and high-mix components. A regular job have around 5-30 pieces board but have high quantity and many type of components. All the time over 1000 pieces of parts on board from 250-350
Electronics Forum | Tue Jul 19 12:36:03 EDT 2016 | jbuckley
My company uses both Juki electric and mechanical feeders. Yes, electric feeders are much more efficient than mechanical as far as pick speed and general feed speed. However, if a reel runs out, it usually takes our operators under a minute to change
Electronics Forum | Mon Jul 25 03:39:25 EDT 2016 | rob
A 200% + increase in load time certainly erases > any thoughts of efficiency in my mind. We have tried the Visker Electric feeders out (Yamaha & Juki)and they are nice and smooth, with a faster recovery rate, also adjustable pitch. However, with
Electronics Forum | Fri Jun 24 22:36:17 EDT 2016 | yokywong
now days, I face a problem for JUKI electric feeder and machinery feeder. i do not know about any of electric feeder. until now, we all use machinery feeder for CF081ER 7' real holder and 15' real holder,CF03HPR ,FF12FS,FF16FS,AF24FS-OP. but this tim
1 |