Electronics Forum: juki and feeders (Page 1 of 57)

0201 feeders

Electronics Forum | Thu May 18 11:55:15 EDT 2006 | RLM

Is a Juki feeder a stand alone unit or does it need to communicate with the assembler ? I can operate a Quad feeder just by hooking it up to a proper voltage source. No need to communicate with a computer. If the Juki's will operate this way maybe I

0201 feeders

Electronics Forum | Tue May 16 14:21:42 EDT 2006 | Frank

Juki feeders will not work on Quad or Tyco machines. Unfortunately, (or fortunately - depending on how you look at it) there are not many, if any, cross-platform feeders. Heck, some vendors can't even swap between models of machines that they sel

0201 feeders

Electronics Forum | Thu May 18 17:34:06 EDT 2006 | Frank

The Juki tape feeders are mechanically actuated. There is a knock pin on the bottom of the feeder bank that will push up to advance the feeder.

0201 feeders

Electronics Forum | Sat May 13 00:25:00 EDT 2006 | George S

My Juki 0201 feeders work very well, but I don't know if they can fit your machine

Europlacer feeders and trolleys

Electronics Forum | Tue Dec 22 17:32:17 EST 2020 | atpico

We are looking to buy a 2nd hand Europlacer p-n-p. We would be very grateful to have a real production competent opinion about EP feeders/trolleys Questions: 1. generally how good/bad are older (Gen1, Gen2) Europlacer feeders and trolleys systems

Europlacer feeders and trolleys

Electronics Forum | Wed Dec 30 13:26:55 EST 2020 | atpico

Hello Dave, Thank you. I certainly look on Used Equipment Mart section. The question was if Gen 1 feeders/trolleys worth to invest or better try to buy EP Gen 2 feeders/trolleys even if significantly much expensier/rare on used machines market.

Europlacer feeders and trolleys

Electronics Forum | Tue Jan 05 07:31:34 EST 2021 | atpico

Great! Thank you! What about Gen1 vs Gen2(NT) EP feeders (not feeder elements)

Europlacer feeders and trolleys

Electronics Forum | Tue Jan 05 07:48:39 EST 2021 | mbass

Go for Gen 2 NT feeders, the Gen 1 Feeders tend to be problematic the older they get whereas the Gen 2 feeders are a much better prospect. I've used 8, 12, 16, 24 and 44mm. Some problems to look out for is pull back of coverlay and removal of waste

Europlacer feeders and trolleys

Electronics Forum | Wed Dec 23 02:16:46 EST 2020 | davef

Used Equipment Mart [nav bar on the left margin of your screen] * SMTnet > Used Euipment Mart > RFQ [nav bar on the left margin of your screen]

Europlacer feeders and trolleys

Electronics Forum | Mon Jan 04 10:47:48 EST 2021 | mbass

Hi, As a user of EP P&P machines for over 20 years I have used Gen 1 & Gen 2 Trolleys. If you can get Gen 2 Trolleys with Elements that would be the preference as there are a few options available on the Gen 2 not on Gen 1. That said the Gen 1 Trolle

  1 2 3 4 5 6 7 8 9 10 Next

juki and feeders searches for Companies, Equipment, Machines, Suppliers & Information