Electronics Forum | Fri Jul 01 18:00:44 EDT 2005 | mrduckmann2000
RB, We have a gold finger problem here at our plant. Our kapton tape came off in the wave process and now we have 8 PCB's that have silver fingers. We are waiting on our new A.P.E. SRS-069 Gold Finger Plater. This mircle machine is going to fix a
Electronics Forum | Wed Dec 07 16:01:45 EST 2005 | JP
I am attempting to reball some PBGA's with no luck. The problem is getting the solder spheres to sit in the stencil apertures and removing excess spheres. I apply light amount of flux to pads of a BGA, align a stencil over a BGA, then pour solder s
Electronics Forum | Wed Feb 01 08:12:04 EST 2006 | Chunks
OK, this is easy. You say HIGH fall out, so I can assume 25 or 50%? If so, run 10 without the heat gun and 10 with. This should show you if the heat gun process is the cause or not. If the relay is a surface mount, hand solder them on. If it's a
Electronics Forum | Fri Jun 15 12:08:49 EDT 2007 | ck_the_flip
Hi Grant, 1st off solder paste data sheets are just "guidelines". You always need to set your specs. based on the needs of your own process and product. Don't ever follow your solder-paste data sheet to the tee, or you're severely limiting yoursel
Electronics Forum | Wed Feb 03 11:31:20 EST 2016 | steprog
Hi, New to this forum. I am an engineer assigned to resolve a quality issue on our production line. It seems that we have been getting small droplets of flux on our boards after the reflow process. Occasionally, they land on a board to board conne
Electronics Forum | Mon May 17 13:43:32 EDT 2021 | kumarb
We are also in the market for wave soldering system but review if they are the manufacturer. Many just resell the product. Check Jaguar who is a manufacturer. Also note the solder pot size and the cost of the solder. Did not know about your vendor
Electronics Forum | Tue Feb 01 21:53:06 EST 2000 | Dave F
Emmanuel: You have choices to prevent the solder paste from flowing to the second side during reflow: 1 Have your board fabricator plug the vias. 2 Put a temporary solder mask on the secondary side vias. 3 Have your designer relay-out the vias unde
Electronics Forum | Wed Jun 30 12:14:40 EDT 1999 | John Thorup
| | We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design). I
Electronics Forum | Mon Nov 05 20:31:09 EST 2001 | davef
Most people do not intend to �solder� Type K thermocouples. They use solder to �attach� the thermocouple. Search the fine SMTnet Archives for a posting by Chrys Shea. 1 Common thermocouple types commonly used for thermal profiling are: * Type K �
Electronics Forum | Mon Jan 30 05:58:39 EST 2017 | rob
Hi all, > > Am new to SMT here. > > I have a very > thin laminate substrate which around 120um > thickess. Being that thin, warpage is constantly > an issue for us. > > For the solder printing part, > we have a number of problems. > > Being s
.gif)
