Electronics Forum | Thu Oct 02 16:29:11 EDT 2008 | kiss
Contact your local Fuji dealer. Your questions are covered on first couple of pages of spec. Your reluctantness to contact Fuji direct sounds as though you are a competitor scratching for info. Pick a phone, call Fuji.
Electronics Forum | Sun Nov 23 13:57:17 EST 2008 | kiss
Contact Fuji America Software department. Pinouts are available for each cable type (COM1 or using Digi board).
Electronics Forum | Sat Nov 20 02:06:51 EST 2010 | kiss
Next Parts:1, Slot#8 -> Next Parts:2, Slot#9 -> Next Parts:3. This represents use parts located in slot#7 first, slot#8 second, and slot#9 third. I hope this clears it up for you, purchase FLEXA when you have enough money.
Electronics Forum | Sat May 28 16:14:04 EDT 2011 | kiss
FOV - Feeder Offline Verification. Kit is generally used with FujiTrax for verification, however it can be used to power up the entire feeder pallet while it sits on the pallet change unit of the M3 or M6.
Electronics Forum | Tue Feb 21 01:41:07 EST 2012 | kiss
If memory serves correct, your part name or part Id must be actual part numbers. You cannot use the device comments for part numbers in F4G. If memory serves correct.
Electronics Forum | Sun May 20 00:11:45 EDT 2012 | kiss
We are mounting 3528 package LEds with pick & > place machine.The problem is , nozzle picks up > the LED , but it stick to the nozzle & not > placed. Then it gives error in the next cycle. > Can anybody suggest the solution? Please advise on mo
Electronics Forum | Mon Mar 11 00:43:27 EDT 2013 | kiss
Is there something in particular you are looking for?
Electronics Forum | Fri Jan 05 16:26:54 EST 2024 | mistrthou
I haven't used one, but KISS was bought out by Nordson, and the newest version of the KISS 103 is the Cerno 508.1. Their earlier Cerno's were almost identical to the KISS 103's. Something to keep in mind if you're used to programming that style.
Electronics Forum | Tue Jul 05 16:29:27 EDT 2005 | stepheniii
The air kiss is to replace the vacuum with air so the part will drop off the nozzle. Every machine I've seen with Air kiss, uses it when discarding a part as well as when placing a part. The air kiss should not be strong enough to blow the nozzle off
