Electronics Forum | Thu Jul 31 08:46:16 EDT 2014 | kurtiss
We currently have a CP4-3 that is having the nozzle change alarm on different holders. there was a part found in the machine and I do not know if it is part of the machine or not, see picture. Any advice on what this part is or how to resolve this is
Electronics Forum | Thu Jul 31 14:07:44 EDT 2014 | kurtiss
I found a bad solenoid and replaced it solenoid 15 on station 11. The machine is still erroring out. I also checked the holders and sensors and they seem to be ok. This error occurs when ever the machine tries to change nozzle sizes on any holder. T
Electronics Forum | Fri Aug 01 08:15:49 EDT 2014 | kurtiss
Thank you, Kurtis
Electronics Forum | Fri Aug 01 11:57:56 EDT 2014 | kurtiss
It turns out it was a misaligned fiber sensor on station 12?, the after rotation nozzle verification.
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
Electronics Forum | Fri Oct 23 10:40:29 EDT 2015 | kurtiss
The machine will allow more functions other then power off, forgot to press reset button. Any one know what ESC 3 means?
Electronics Forum | Tue Sep 24 15:32:22 EDT 2019 | kurtiss
During production our MPM Accuflex stopped working. When going into "Play" mode to run production it almost instantly Pauses. When going into vision setup it fails to load the PCB saying "The PCB Did Not Load". Ignoring this error and trying to read
Electronics Forum | Wed Jun 03 19:19:37 EDT 2020 | kurtiss
Hello, I am having an issue with a Fuji CP4-3 where during the nozzle center the image displayed by both the wide and narrow view camera is a black square. We have checked the cable coming from the 4400 Card and all checks out. We have also pulled t
Electronics Forum | Mon May 09 21:07:53 EDT 2022 | kurtiss
Currently we have a line running a MPM Accuflex. We are working on setting up a second production line and are in need of a new stencil printer. The two machines available within budget are a MPM Momentum and a Ekra X6. We have been happy with the MP
Electronics Forum | Thu Sep 22 14:09:06 EDT 2022 | kurtiss
I am looking for 3rd party support for an Ekra screen printer in the northeast Ohio area. for service, calibration, and spare parts. Due to cost, support through Ekra is not an option.
winsouce.jpg)