Electronics Forum: labels (Page 1 of 55)

Pick and place labels

Electronics Forum | Thu Sep 23 11:28:57 EDT 2004 | Frank

We have placed labels using the Hover-Davis label feeders on our Juki machines and we used standard nozzles. Are your labels an odd shape where a standard nozzle won't work?

Pick and place labels

Electronics Forum | Thu Sep 23 11:50:54 EDT 2004 | JB

We are using a standard nozzle Once placed, the label is not flat, the ends of the label are slightly lifted on both ends. The label is .650 x .200 Have you guys run into a similar problem?

Low cost Kapton labels

Electronics Forum | Fri Jan 16 18:37:03 EST 2004 | adlsmt

Anyone have an inexpensive vendor for high temp board labels?

Low cost Kapton labels

Electronics Forum | Sat Jan 17 09:12:51 EST 2004 | Tom B.

Look at Brady Labels http://www.bradyid.com/brady/htpdv1r0.nsf/ISDWebIndex/79CD8A7D08591909862569F40059FD70 Tom

Pick and place labels

Electronics Forum | Thu Sep 23 10:28:33 EDT 2004 | JB

We are placing labels using a Hoover-Davis feeder with a GSM. Anybody else out there doing this? My question is: Are you using a special nozzle for this operation?

Pick and place labels

Electronics Forum | Tue Sep 28 12:44:30 EDT 2004 | JB

You are right, basically our options are down to a custom nozzle. Pushing down the label is not the route that I would go with. Thanks for your input and good to hear that you guys found a way around it.

Pick and place labels

Electronics Forum | Fri Sep 24 12:02:57 EDT 2004 | Frank

Yes, I can see your problem, the nozzle makes only good contact in the center and so the ends don't make good contact. The ends tend to curl up during reflow. There were two suggestions to solve this. 1) Let the operator push down the labels befor

Low cost Kapton labels

Electronics Forum | Mon Jan 26 09:45:34 EST 2004 | Michael

Hi, send your enquiry to: www.mueller-ahlhorn.com

tamper proof (but removable) labels

Electronics Forum | Wed Jan 30 13:45:59 EST 2019 | slthomas

I'm wrestling with the infamous adjustable torque drivers on the production floor. Despite a procedure that clearly forbids it, we still have the occasional know-it-all that will just crank the knob until the desired setting is visible in the windo

Removable Feeder labels from dymo/Brother type printers????

Electronics Forum | Mon Aug 18 11:22:27 EDT 2008 | pjc

Try here: http://www.bradyid.com/bradyid/scv/100769/100769/Labels/Printable-Labels.html

  1 2 3 4 5 6 7 8 9 10 Next

labels searches for Companies, Equipment, Machines, Suppliers & Information