Electronics Forum | Mon Jul 28 14:01:05 EDT 2008 | pcbbuilders
thanks, looks like an interesting product. any idea of the cost? they don't list it on their site. not sure if i can afford it yet.
Electronics Forum | Tue Jul 29 10:46:17 EDT 2008 | realchunks
Oh, well if you can profile, model your profile to the profile supplied by the paste manufacturer. Anything outside of their recommended profile is all experimantal.
Electronics Forum | Tue Jul 29 10:53:58 EDT 2008 | pcbbuilders
Some profiles can be difficult to get exactly, so I was wondering what effect a slight deviation might have.
Electronics Forum | Tue Jul 29 14:20:03 EDT 2008 | realchunks
Slight variations should have little impact on your product under normal conditions. All depends on your board.
Electronics Forum | Mon Mar 17 07:00:34 EDT 2008 | ectan5117
Hi, During SMT process, i found that solder splash on the gold pad. The distance between the COB pad with component pad is about 1.25mm. My question is what material can used to cover the COB pad without bringing contamination. And i am welcome to
Electronics Forum | Sat Aug 02 08:06:11 EDT 2008 | pcbbuilders
Is there a limit to the time that most components can stay at temperatures around 130-200 deg c? if i slow the time, the first 4 zones will be at this temp for about 5 minutes in no lead process. i am concerned that some chips wont be rated at this t
Electronics Forum | Mon Jul 28 16:48:54 EDT 2008 | pcbbuilders
my oven has a built in profiler, it works fairly well, but it can not predict changes. my main concern was about the time right before reflow. i know that's where the flux is activated and i was worried that i may be spending too much time at the tem
Electronics Forum | Fri Jul 25 15:54:22 EDT 2008 | pcbbuilders
I am trying to optimize my reflow profile. i have a 5 zone oven. lead-free: for the 1st 3 zones, i am good, at about 150-200 deg for 150 seconds. during the 4th zone, i am at a temp of 200-220 for 50 seconds. during the 5th zone, i am at 220-245 f
Electronics Forum | Sat Jul 26 07:42:49 EDT 2008 | pcbbuilders
I am not very concerned about production time, but it is always a thought! Quality is more importnant of course. We have 2 different pastes, with almost identical requirements. We can get close to their profiles, but i am worried that i am spending
Electronics Forum | Mon Aug 04 09:30:16 EDT 2008 | grics
If you have concerns, you can look at the datasheet for each component or contact one of their application or materials engineers and find out what the components are rated for...process-wise. IE, how long can I be in the oven with this part, at what