Electronics Forum | Tue May 29 16:52:07 EDT 2001 | hussman
By far the easiest way is to track solder paste measurement on your board - or solder defects after reflow (key word- easiest). Why spend 2 weeks examining a stencil when it clearly doesn't make defects, or IS making defects. I find using 2-D data
Electronics Forum | Thu May 24 09:11:12 EDT 2001 | Grant Petty
Hi, I would agree. We purchased a TP9 just the slow machine, but we were a small company at the time, and it worked fantastic. Almost no maintenance, and it's a dream to changeover. The serivce in Australia is also very good, but that does not appl
Electronics Forum | Wed May 16 10:37:34 EDT 2001 | davef
Similar to my response to your previous posting on this topic dated 5/8/01, things to try are: 1 Contact your non-supplier [Streckfuss] using the contact points at http://www.streckfuss.com/wave_soldering.htm, obtain source drawings for components o
Electronics Forum | Thu May 17 22:41:05 EDT 2001 | davef
Hi Bob Still getting the cushy jobs, eh? [Tennent's and McEwans are two of my favorites. "Ahh, Beer! My one weakness...my Achilles Heel, if you will..." Homer J Simpson Quote 89/114] Under "Acceptable" for "Pin-In-Hole/Intrusive Reflow Inspection
Electronics Forum | Mon Jun 18 17:41:07 EDT 2001 | genny
Hi, I put this on the technet forum, and I know some of the same people are here, but I thought I might catch others here as well. We have PCB's which are populated at the CM level with no-clean solder paste. However in house we use a solder wire s
Electronics Forum | Mon Jun 25 20:39:08 EDT 2001 | ianchan
Hi mate, no complete info given from what i see, so just some humble comments, mayhaps you review : 1) PCB pad finishing - Copper+nickle plated? coz if so, nickle is a KILLER to good solder wetting. what we did back here, was to HAL coat the nickle
Electronics Forum | Tue Jul 24 19:26:20 EDT 2001 | johnmaetta
Thanks Dave. We develop high-speed telecom PCB assemblies that use uBGA and other fine pitch components. Our policy has been to use an NC process at our CM. Our engineering group, who is also a customer, and uses these assemblies for development,
Electronics Forum | Wed Aug 01 11:03:20 EDT 2001 | Chip Gill
I read your request for design information on panel layout for V-scoring, and felt the need to respond. Scored PWB's are indeed more efficient to produce and depanel than tab routed PWB's, but there are also drawbacks associated with this method. T
Electronics Forum | Mon Jul 30 11:10:41 EDT 2001 | hinerman
There are several things to look for in a compliant tooling system 1. How much force per pin is required to lock the pins in place? This is especially important since you will be multiplying by the total number of pins on all modules. 2. Is ther
Electronics Forum | Tue Aug 07 01:16:27 EDT 2001 | mugen
When I was reading the smartsonic fantasy, I ended hospitalized for infectious laughs, and side split'in stitches..... Now that cold reality has eased my pain, I must with calm headed purpose, mark my agreement to the Mr.Sean, that salespersons can