Electronics Forum | Mon Jul 16 10:51:09 EDT 2007 | patrickbruneel
D. Hillman, et al., �The Impact of Reflowing a Pb free Solder Alloy Using a Tin/Lead Solder Alloy Reflow Profile on Solder Joint Integrity,� International Conference on Lead-free Soldering, CMAP, Toronto, Ontario, Canada, May 24-26, 2005, http://www.
Electronics Forum | Thu Jul 19 04:38:33 EDT 2007 | chrispy1963
I took a Lead Free troubleshooting Class at SMTA in Chicago last September taught by Phil Zarrow. He told us during that seminar that its not a good practice to cross contaminate Leaded and Lead Free components but IF it is necesary than using lead
Electronics Forum | Mon Jul 16 10:17:22 EDT 2007 | realchunks
Yes you can use no-lead parts in a leaded process. Your solder joints will be weaker than they once were unless you change your solder paste. You can try to improve this by running a hotter reflow temp, but be careful since your flux was not design
Electronics Forum | Fri Jul 13 16:07:42 EDT 2007 | wana
Hello All. Can the experts in the lead free field guide me to the articles / data confirming that it is OK to use lead free components in the normal "leaded" (Pb) SMT process. And also if any changes in the process would be required to be made. Th
Electronics Forum | Mon Jul 16 09:53:36 EDT 2007 | ed_faranda
Yes, you can use lead-free parts in a leaded process. And the other is true as well, no-lead free parts in a leaded process. BUT, you should not use leaded parts through a non-lead wave solder process and of course, your board will not be RoSH.
Electronics Forum | Mon Jul 16 10:28:08 EDT 2007 | wana
Thanks guys for the suggestions. But, what I am looking for is data, papers, articles to support this process of using lead free parts in leaded process. Again thanks for any help that you can provide.
Electronics Forum | Thu Jul 19 09:23:52 EDT 2007 | patrickbruneel
Chris, To my knowledge the only difference between leaded and lead-free components is the termination plating. What has changed in the component design that makes them resistant to higher temperatures?
Electronics Forum | Thu Jul 19 12:25:51 EDT 2007 | patrickbruneel
Amen to that Hussman. The new lead-free world is not based on science or environment it�s all about $$$$$. And as I said before the promoters of lead-free care less about quality or reliability they just take this great opportunity to double their
Electronics Forum | Sat Jul 14 08:49:16 EDT 2007 | davef
While you're waiting for others to respond, search the fine SMTnet Archives.
Electronics Forum | Fri Jul 20 08:09:09 EDT 2007 | chrispy1963
In passives I dont know if anything changed at all other than the terminal plating. As for Active components there has been much engineering done to allow for the extra heat needed to liquify say SAC305 or other lead free pastes without damage to th
