Electronics Forum | Mon Jan 18 10:49:22 EST 2010 | pcbrookie
Hello all, One of our resistor arrays is becoming detached from its balls after reflow. This is the second instance of this happening. The balls are clearly soldered to the board, but the actual package is coming off (package pads are quite bare).
Electronics Forum | Tue Feb 21 17:08:16 EST 2012 | cellis
We finally can't avoid adding wave solder to our > process anymore. For lead-free, medium sized wave > I'm leaning towards mid 2000s senju units as the > best fit. I've never run their equipment. > Opinions? > > As a point of reference for our
Electronics Forum | Tue Aug 13 10:09:10 EDT 2013 | dyoungquist
We have a Heller 1707EXL that we use for lead and lead-free production. It has both a mesh belt and edge rails. We run 90% of our assemblies on the mesh belt (leaving the edge rails wide open). I have noticed when profiling a board on the mesh bel
Electronics Forum | Tue Dec 24 09:34:55 EST 2013 | emeto
Hi, it is a not given clear here. I will tell you some basics about the profiling: 1. Profile stages A. Preheat - the board preheats from room temp to 130-150C depending on the paste B. Soak - 150-170(or other range depending on the paste). here th
Electronics Forum | Thu Feb 27 18:07:13 EST 2014 | emesystems
The ISL12020 real time clock comes in a 20 lead DFN, and includes a 32kHz crystal in the package. The terminals of the crystal and oscillator come out to external pads and are highly susceptible to leakage to the neighboring power supply pins. With
Electronics Forum | Tue Dec 16 22:09:36 EST 2014 | deanm
The critical operations where cross contamination can occur is the paste printer, the touch up station and the hand soldering station. Hand insertion should not be a problem if the parts are kitted or issued with proper control. If possible I would
Electronics Forum | Wed Oct 03 23:42:32 EDT 2018 | gaintstar
SMT Reflow Oven Factory http://www.flason-smt.com/product/SMT-Reflow-Oven-Factory.html Introduction of SMT Reflow Oven Factory: 1. Windows XP platform, user friendly interface and easily swap between bilingual of English & Chinese. 2. Digital contr
Electronics Forum | Fri Dec 20 18:48:18 EST 2019 | rhormigox
Reflow with lead free 96.5 /3/0.5 No-Clean T4 brown-orange burn color on parts While I have been an observer for years, now I am mostly new into reflow process. I tried to reflow a big 4 Layers board and without knowing much about solder pastes oth
Electronics Forum | Thu Dec 26 17:13:43 EST 2019 | rgduval
Doesn't really look like no-clean to me...typically, no-clean encapsulates the solder joint after reflow, trapping any organics. This looks like plain-old water soluble flux, that cooked a bit too much in reflow. As you noted, it cleaned up with
Electronics Forum | Mon Aug 24 23:44:08 EDT 2020 | kylehunter
Hey all, We recently purchased a second hand EBSO SPA-400 selective. Other than the normal pain of a used machine, everything seems to run OK. We ran some preliminary tests, with really bad results. There were tons of shorts and icicles. The only noz