Electronics Forum | Thu Jan 06 10:56:32 EST 2005 | Rob
If the Leds are not in close proximity then LDR's can be used connected to a node on the ICT/wired into a micro for a simpler board - you can then test for luminous intensity as well as absence. Else you could use a cheap CCD camera with some simple
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Tue Oct 09 10:29:47 EDT 2018 | dfl
Thanks Bob. Using a flashlight helps a lot, indeed. Is "re-adjust the angle" just a bend on the LEDs heads (by hand)? I will try. To replace de LEDs, can I use white ones? I believe with the reds I get less light than whites, but maybe the camera ne
Electronics Forum | Thu Aug 27 09:04:54 EDT 2015 | fcmtechnician
HI are the LED from Ilumination on?
Electronics Forum | Thu Jul 30 07:25:09 EDT 2015 | buckcho
Hello, I haven't worked with such machine, but do you have a led lighting, like in cp45, which is newer? Maybe there is something wrong with it and it is not lighting up?