Electronics Forum | Tue Apr 03 05:20:42 EDT 2007 | Haris
HI I think it is matter of light which is throwing by ur Machine camera, Decrese its light level and then try i believe it may works, because camera only recognises its leads/pins as it reflects back & not the other things, or choose the ODD CHIP/ I
Electronics Forum | Fri Apr 06 00:08:41 EDT 2007 | barney
What software level do you currently have on your machines? If you have UPS+ 6.2.x there is a huge improvement. In the SOIC/QFP or any leaded catagory you will find a check box under the vision tab called noise filter. Check this box and the software
Electronics Forum | Wed May 02 11:51:40 EDT 2007 | flipit
Check with Universal on service. The GSM is a solid machine. Very well built. The older machines will run under IBM OS2 OS. Nothing wrong with this OS. There have been some vision system upgrades also. The older GSM might have the AIS3500 or ne
Electronics Forum | Thu May 03 16:01:06 EDT 2007 | geb
Hi, We are in the market for some Inspection Equipment. We have never bought any before but have trialed two types so far. A Mantis system, and a camera system with built in microscope. We are keen on getting the camera with scope so that we can use
Electronics Forum | Mon May 07 15:54:22 EDT 2007 | joeherz
If you're looking for something for less than $5-10k, you should consider setting up a point-of-use air drying system. If you can supply fairly dry air from a house system to the point of use dryer, you can acheive humidty levels below 2% easily. W
Electronics Forum | Fri May 11 10:48:51 EDT 2007 | Rob
Hi Lupo, Are you talking about laser trimming the current limiting resistors in front of the LEDs, whilst dynamically measuring their output to get set light levels? If so then you need a laser trimmer & a very good photodiode/comparator feedback l
Electronics Forum | Tue Jun 19 17:42:38 EDT 2007 | dyoungquist
We run a TP9 machine and had a very similar problem with it. On a TP9 machine there is a power supply board where all the voltages are generated. It is located on the bottom side of the unit. The problen was with one of the fuse holders. The co
Electronics Forum | Wed Jun 27 11:59:55 EDT 2007 | samir
*Preheat zone *Maximum slope is a time/temperature relationship that measures how fast the temperature on the printed circuit board changes. The ramp�up rate is usually somewhere between 1.0 �C and 3.0 �C per second, often falling between 2.0 �C and
Electronics Forum | Wed Jul 11 14:27:56 EDT 2007 | fredericksr
1) Swapped it out a few weeks ago to attempt to combat the problem ... Great minds eh? 2) I'll try changing the position setting to see if my yields improve. 3) Ahh yes, in fact, I have verified that our vacuum levels are low (range ~130). The
Electronics Forum | Thu Jul 12 07:52:08 EDT 2007 | cyber_wolf
I agree avalancher. Your description is a valid point. But, I am still under the impression that the vac level is a separate issue. His original problem was 0402's missing off the board ,and weird measurements showing up when parts get rejected. I w