Electronics Forum | Fri Nov 18 15:45:27 EST 2016 | jg_annaanthan
Hi all, my site using x-ray machine "Agilent 5DX Series 5". The tester will hang around 10- 15 min during perform automatic startup at level "Delta Z". My site, we already change Front & Rear laser, burn galil, performed manual startup, total shutdow
Electronics Forum | Wed Mar 15 12:39:24 EDT 2017 | cyber_wolf
Customer precedes standard, but customer must be educated and informed on what is achievable with their design and what is accepted as industry standard practice. My guess is that the negative effect of those voids is negligible. {Voids at the sold
Electronics Forum | Tue Aug 01 09:49:53 EDT 2017 | dontfeedphils
Our Engineering team handles all initial programming and debugging of programs on the floor, with a person "specializing" in a certain area, but with all Engineers cross-trained well enough to take on the job if need be. Technicians are responsible
Electronics Forum | Thu Oct 05 10:25:13 EDT 2017 | davef
Consider ... * National Physical Laboratory (NPL) [http://www.npl.co.uk] did an extensive amount of research on proper frequencies and power levels for ultrasonic cleaning, maybe in late 1980s or early 1990s. That report might help you sort through
Electronics Forum | Wed Oct 25 02:17:20 EDT 2017 | tsvetan
Out of these only Eagle and KiCad are capable to do designs above basic amateurish level. Eagle is in great decline since they were aquired by Autodesk and changed their licensee policy. I'm biased but KiCad will be good choice for long term - alw
Electronics Forum | Wed Jan 31 02:56:53 EST 2018 | robl
Hi Fluxgate, Doubt it's the laminate unless you have embedded components. Nickel is ferromagnetic (can be magnetised),so I would expect some level of magnetism in ENIG, but not silver. Are you 100% sure it was immersion silver and not something
Electronics Forum | Fri Apr 06 06:01:06 EDT 2018 | reckless
Do you think this could be taught remotely through skype? I really don't have the budget for $10k in training but can afford $1k. We hope to sort out leveling, power, air issues ourselves. GSMs look highly complex. Is it possible they take much
Electronics Forum | Wed Mar 28 15:26:10 EDT 2018 | dleeper
one caveat to be aware of is the power requirements of many machines. Most 'industrial level' pick and place machines, as well as reflow ovens will require 3 phase power. it sounds like you are trying to set this up in an office type environment. Do
Electronics Forum | Wed Aug 08 07:17:08 EDT 2018 | milena_k
Hi, do you know any company who provides Design for Assmbly analysis of PCBA assembled in the housing (with other components like gears, radiators, screws etc.)? By DFA I mean analysis from the mechanical side, in range of dimensions, tolerances, me
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already