Electronics Forum | Tue Mar 11 19:43:56 EDT 2008 | davef
While it's possible, we don't think that soldering a wire of this low of an AWG to a board is a good idea. We're concerned that mechanical vibration and heating / cooling will stress the solder connection to the point of failure during routine table
Electronics Forum | Fri Feb 29 16:42:34 EST 2008 | vikkaraja
Hello again, Has anyone experience any problem with their vision system on the DEK machine. Machine had been running fine for at least one year without any major problem until this week. Machine's response is very slow especially the vision system. M
Electronics Forum | Wed Mar 19 12:48:29 EDT 2008 | ratsalad
From what I understand, the major reason Sn prices recently escalated was a crackdown on black market Sn mining in Indonesia, where most of our Sn originates. Add to that increased demand (not necessarily from RoHS, but from China, India, and other
Electronics Forum | Thu Mar 20 17:39:41 EDT 2008 | boardhouse
FSW, Another suggestions is if you have rail on your product and you are concerned about stress fracturing certain components you could add a routed slot to add relief in that area. So when you snap the rail off their would be no stress in that area
Electronics Forum | Tue Mar 25 14:05:16 EDT 2008 | flipit
X7R >Z5U,Y5V. Y5Vs crack more than NPOs. Ceramic resonators crack often as well. I found that the chop style like the Fancord VPD5 is the lease stressful of the V-Score cutters. We have run as close as 0.025" to the edges with 0805s with no crack
Electronics Forum | Wed Mar 26 09:32:46 EDT 2008 | nibirta
well i do not know if u fixed this problem already. But i cand share form my experience some info with u. We used a vigon A200 solution for such an application. the cleaner is good. But...it gives u troubles depending on the quantity of flux. It can
Electronics Forum | Thu Mar 27 16:40:45 EDT 2008 | slthomas
(or just some static-safe foam tape) I need to seal a wire terminal block to a board for conformal coating purposes. Currently we glue it to a shim and glue the shim to the board (yuck), but I want to use die cut gaskets if I can make it cost effec
Electronics Forum | Sat Mar 29 15:29:06 EDT 2008 | aw
I am printing a ceramic paste through a 160 mesh screen that should have a theoretical wet print thickness of 53um but the only way I can get the print that thin is to increase down stop and slow the stroke. This is causing problems with the mesh, s
Electronics Forum | Fri Apr 11 09:06:40 EDT 2008 | markhoch
I believe we have the Michigan Occupational Safety and Health Administration to thank for our awesome new glasses. I took some of the advice that I was given on here and bought my own Crew Rubicon Safety Glasses from Safety Glasses USA. So at least I
Electronics Forum | Tue Apr 01 08:28:19 EDT 2008 | cyber_wolf
DANGER WILL ROBINSON ! DANGER ! If your operators are not real careful the OEM support pins can get under the table frame and bend it. I have seen this happen more times than I would like to discuss. CP's must have the following: 1. Proper part hei
.gif)
