Electronics Forum | Thu Jun 17 16:18:22 EDT 1999 | Earl Moon
| | Has anyone had problems with the Weller MT 1500 IRON/TIP solder station? | | Please advise your problem and resolution. | | | | ddj | | 6/16/99 | | | I don't like to use the needle tips (MT2 series), but the rest of the tips work fine. The MT2
Electronics Forum | Tue Jun 15 14:45:11 EDT 1999 | C. Cross
| I am looking for more information about: | | 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; | | 2) There is some influence of doble wave solder machine (temperature, flux, etc) i
Electronics Forum | Mon Jun 14 12:16:03 EDT 1999 | Earl Moon
| I am looking into Alpha's system, and would appreciate some feedback from anybody using it currently. I am concerned about about the life expectancy of the foils if they are clamped and unclamped every couple of days, and what happens if one of the
Electronics Forum | Wed Jun 09 15:03:53 EDT 1999 | Earl Moon
| In past PCB designs I have cleared all traces from all layers | (except pwr/gnd) from fiducial area. It has come to my attention that this is only necessary on the side where fud is placed. Which is the correct method of design using a fidicial?
Electronics Forum | Mon Jun 07 22:30:28 EDT 1999 | Dave F
| | | I was wondering what measurements are used to define pitch? | | | | | Frank: John's correct with the most common definition, but there can be others, depending on your perspective. TTYL Dave F | | | | Pitch. The center-to-center spacing b
Electronics Forum | Sat Jun 05 07:37:25 EDT 1999 | Dave F
| We are changing from through-hole to SMT, wondering what pitch requirements would an 8 pin SOAC require for pick and place? We think that this would be our finest pitch part. | John: Never heard of an "SOAC." SO packages are 50 ptch (50 mil, 1
Electronics Forum | Wed Jun 09 11:50:13 EDT 1999 | Cunli Jia
Scott, The SMT Forum has been a place for sharing equipment experience. It has served as a user group for all capital equipment, as well as material and supplies. We used to consider putting up an equipment forum but more users felt that everythin
Electronics Forum | Sun Jun 13 08:42:28 EDT 1999 | Brian Ellis
| Scott, | | The SMT Forum has been a place for sharing equipment experience. It has served as a user group for all capital equipment, as well as material and supplies. We used to consider putting up an equipment forum but more users felt that eve
Electronics Forum | Thu Jun 03 18:00:33 EDT 1999 | John Thorup
.020" pitch spacing. Which have yielded my process excelent results. | | My main stencil supplier is I-Source in Irvine, CA and has pretty much standardized on 100% lazer cut stencils for competetive pricing. | | Hope this helps. | | | | Deon Nunga
Electronics Forum | Wed Jun 02 22:25:23 EDT 1999 | Jeff Sanchez
To All Who read My bashing of the Placemax equipment line, I am posting this apology because it was brought to my attention by the owner of the company that I was out of line. That my bashing was not just! I gave it some thought and he is right!