Electronics Forum | Wed Oct 26 16:07:35 EDT 2005 | lizard
Is anyone using the XD7600 X-Ray from Dage Precision Indutries?
Electronics Forum | Thu Jul 11 18:00:34 EDT 2002 | jax
Tony, Do an archive search for "lizard". Some times all you really need is a lizard tongue. No machine is complete without one.
Electronics Forum | Fri Jul 12 12:30:56 EDT 2002 | soupatech
I just go off the phone w/ Fuji and they seem to think that the lizard tounge (used another name, same idea) is only available for the IP3. They had a few other suggestions for adapting the IP2 like a rubber pad for the carrier or building "rails" to
Electronics Forum | Fri Jul 12 11:15:00 EDT 2002 | soupatech
I did the search for "lizard" and found a few references but..... WHAT IS IT? I will look into getting some dummy tape and reel BGA's. I just took over this dept. and I am still trying to get an inventory of what size and type feeders we have. It d
Electronics Forum | Thu Jul 11 20:36:43 EDT 2002 | cyber_wolf
It will place BGA's, but you will be centering by using the part outline. The IP2 cannot be adapted to do individual ball inspection.(You may already know this) As far as getting the part to stay on the part shuttle, I am sure that there is somethin
Electronics Forum | Fri Jul 12 12:04:51 EDT 2002 | jax
The Lizard Tongue is just a thin metal strip that, when actuated, slides over the BGA component and holds it down during transport. If you contact FUJI, they should be able to give you a part number, and install instructions..... maybe even the real
Electronics Forum | Fri Oct 29 12:18:45 EDT 1999 | stefano bolleri
We have also placed BGAs with IP-2, with no problems. Ours were 50 mil pitch PBGAs, and as Doug says the perimeter is more than enough to place the part. We have only placed from matrix tray so far. The ONLY problem is the center array, for parts tha
Electronics Forum | Sun May 30 12:33:36 EDT 1999 | Earl Moon
| | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but according
Electronics Forum | Sun May 30 15:11:10 EDT 1999 | M Cox
| | | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but accordin
Electronics Forum | Sun May 30 18:34:04 EDT 1999 | Earl Moon
| | | | | | Is it possible to place parts that do not have leadframes exposed when looking from the top side of the part such as BGA's using a Fuji IP1 with a SMD1 vision (Binary) system. I realize that the IP1 does not have front lighting but accord
