Electronics Forum | Tue May 21 12:58:15 EDT 2013 | highmillr
We have 2-Samsung 431's followed by a 421 on our line..We run different revision boards with similar parts. Is there a way I can run one revision feeder set up.Then switch over to the next job without having to switch feeders around for the new progr
Electronics Forum | Tue Jul 30 15:04:54 EDT 2013 | ericrr
Is it just possible that H49s crysats are hard to place, so it looks like it has been place by a perfectionistic instead of looked like it had a parachute type loading. This is the H49 short stubby type crystal about 10 mm long (width) about 4.5 mm
Electronics Forum | Fri May 02 14:30:48 EDT 2014 | jimmyboz
The last 3 posts were quite refreshing. I never said, but, I may have implied that "no tools necessary" is OK. No way. I honestly lost sleep over this thread. I was kinda playing "devil's advocate", but man what a response. I have been on every s
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
Electronics Forum | Mon Oct 13 16:32:55 EDT 2014 | tombstonesmt
Designator>Part Number>Alternate. 2D labels are placed on all slots of the machine, operator scans slot, scans reel with unique material ID. Green light if it's good, red light if it's bad. Our software cannot lock out a machine if there is an incorr
Electronics Forum | Thu Nov 20 16:51:48 EST 2014 | joe98375
gregp: Our PTH process has not changed in many years. Our products are fairly simple as far as electronics goes and everything gets potted anyways. ~90% of everything we build is single sided TH with ~ 100 solder joints per board. Each board is ~
Electronics Forum | Thu Feb 12 10:06:00 EST 2015 | rgduval
Funny, I just had this discussion on LinkedIn. Must be the season. It is always acceptable and preferably to profile every assembly, if you have the time, resources, and equipment to do it. That is the only way to get the most accurate information
Electronics Forum | Mon Jun 08 21:44:40 EDT 2015 | superlen
Thanks for the feedback and the confirmation that it is, in fact, a bug. I have trained my operators to always use file Save at the end of the day (up to a network drive) & then I have an external program that archives the daily setup back into our r
Electronics Forum | Fri Nov 20 00:14:23 EST 2015 | ttheis
To clarify- what I have is: 1. Manual stencil print process 2. Dynapace conveyor into GSM 3. Dynapace conveyor out of GSM into oven So what I need is a way to tell the conveyor into the placement machine to "go" when a board is loaded onto it after
Electronics Forum | Mon Feb 01 04:57:08 EST 2016 | oxygensmd
If you can use the standalone mode then choose the program on "option" and somewhere you can load program - "aktuell". The "aktuell" program is the last program what was downloaded on this machine. In SiTest you can test and calibrate the machine. Y