Electronics Forum | Wed Jul 24 06:20:11 EDT 2013 | JB
Hello, we have just bought a used nutek ntm110l and are looking for an instruction manual, anyone know where I can download one? Issue we have is that the bottom conveyor is constantly running, is there anyway to stop it? until we load a rack? some j
Electronics Forum | Thu Jul 25 16:13:46 EDT 2013 | markhoch
We occasionally have the same issue with ours, but it is caused when the sensor, (that is supposed to detect when the magazine has emptied), has been knocked out of alignment. If you a transmitter/sensor set mounted at the exit end, make sure that i
Electronics Forum | Wed Aug 28 20:01:17 EDT 2013 | vinodkumar
can anyone help me how to get Siemens Line computer installation floppies or someone mail me the contents of the floppies of 00345544-01,00345542-01. I assume it is boot disk of 3-4 numbers. Request you to mail it to me or load it to a site and give
Electronics Forum | Wed Dec 18 20:58:52 EST 2013 | bestglobalsmt
we bought a 2004 DEK INFEX and are getting an error prior to the software loading up fully. An application error has occurred. DEK_PCCM.exe after canceling out a second error pops up e108151 Failed to create axis controlling threads. Abort the
Electronics Forum | Thu Jan 30 11:21:18 EST 2014 | emeto
Hi, we do that for some of our assemblies(the only difference is that our cut in the PCB is bigger and the LED leads step on the paste right away). we place these manually. I assume that you can send them for tape and reel, and if they can find the r
Electronics Forum | Fri May 09 00:18:42 EDT 2014 | tuanly
To all experts in house, If by chance any one can tell me where to buy or down load the Owner Manual /User guide book for Quad -QSP-II SMT machine. Or step by step instruction how to teaching board Fiducial on this Quad QSP-II. Thank you all in adva
Electronics Forum | Tue May 27 04:52:25 EDT 2014 | hemant_pang23
Need help to resolve the problem in DEK265 paste printer The error messages are as per following details 1. When switch on the Machine we are getting error message like " Rising Table Error" -Position error. 2.While loading the Mint we are get
Electronics Forum | Thu Oct 02 15:28:19 EDT 2014 | arifa_anees
it all depends on the situation, your circuitry and components. ground place should always be below or above the signal and power traces to minimize loops and reduce EMI generated by the board.If you have multiple power voltages and a 4-layer board y
Electronics Forum | Wed Oct 15 07:14:42 EDT 2014 | alexeis
Hi, We have developed solution called Setup Center that helps you to verify online/offline verification. Please read about a solution on our website: http://www.proventustech.com/#!-setup-center-for-samsung/cjeg If you have any questions, you can
Electronics Forum | Thu Oct 23 15:26:56 EDT 2014 | dhollland
One thing our operators do is compare the part marking at the end of the old reel to the part marking at the beginning of the new reel. We also send the operators sheets of paper that tell what component should be at what location and this sheet also