Electronics Forum | Sun Jan 24 20:11:45 EST 2010 | wmeliane
Hi I would like to get feedback on which of the following 2 machines to buy: -option 1: My100 with single Midas head -option 2: D1S with single P&P head I have experience with the Siemens D series. However I have no real experience with Mydata... Is
Electronics Forum | Mon Jan 25 17:13:53 EST 2010 | bing007
I am working on a vcd 8 with a problem of loosing the 5 volts supply. We have fitted a new supply that also provides the 15 volts. When we remove the connector on the power chassis for the 5 volts the power supply shows OK. When fitted the 5 volts is
Electronics Forum | Mon Feb 01 14:04:12 EST 2010 | bing007
Found the problem. Thanks for the pointers. I had set the voltage to 5.00 volts as it was reading 4.86 volts. I still had the problem. A slghtly burnt wire going into the spade connector on the back of fuse holder 12 (5 volts). The reason the voltage
Electronics Forum | Thu Feb 04 09:18:18 EST 2010 | mika
Problem! Then replace the motor! Why not replace be belt anyhow? How long was it since the last time you replaced any belt? Another thing you could also do; In the LP (Low Power) chassis lower front left, find the correct motor servo card and "Null
Electronics Forum | Wed Feb 03 18:52:46 EST 2010 | mika
Hi, Not really. "In aerosol sprays, friction is generated as liquids race through the plastic tubes of the spray can. This creates powerful electrostatic charges (ESD) of up to 12,000 volts; ESD voltages as low as 150 volts can cause ESD damage." I
Electronics Forum | Wed Feb 17 14:45:40 EST 2010 | dcell_1t
Is your oven adjusted correctly for temperature > and blower and conveyor speed? As far as blower settings it only has a Hi-Mid-Low setting (is a heller 1809), and we have been working with all at Hi speed since line was started (1.5 year ago). Co
Electronics Forum | Tue Mar 02 16:49:37 EST 2010 | davef
For a earlier, similar thread posted by an old friend Cal Driscoll ... Classes of BGA inspection machines * GO/No-go Machine specs: 50Kv, limited zoom, perpendicular head, board size. * Low to mid range machine:+75Kv, Angular inspection,zoom,image c
Electronics Forum | Tue Mar 09 14:53:16 EST 2010 | davef
Resistivity Of Solvent Extract [ROSE] is a bulk ion contamination [BIC] test method. It should thought of as a process control tool used to assess ionic contaminants. Don't consider it an acceptable tool for establishing 'GO-NOGO' limits. The stan
Electronics Forum | Thu Apr 01 15:33:19 EDT 2010 | davef
"-How do these lint-free rags remove the flux that seeps under components = no matter its a no-clean material and we are removing for esthestics only." Don't think so ... Let's be clear. Low residue fluxes are benign only if: * Applied in amounts ac
Electronics Forum | Fri Apr 30 07:39:54 EDT 2010 | jdengler
We do a similar part on a Fuji IP3. Set table speed to low. I do not know the QP, but if it's similar to the IP make sure the board clamp/unclamp is smooth. On our IP it got dirty and was jerking causing the board to jump a little which bounced ou