Electronics Forum | Thu Jul 26 04:26:59 EDT 2018 | Robl
Hi VChauhan, I'll preface this by saying I am no DaveF. Voiding can occur when the flux in the paste boils and vapourises, the expanding vapour needing somewhere to go displaces the paste. So... what we have done in the past: 1) Step the stencil d
Electronics Forum | Fri Oct 12 12:12:13 EDT 2018 | davidsmullins
We have some fairly standard 0.1" pitch, two row, shrouded, through hole headers soldered onto a thick backplane. There are tiny inspection holes along the bottom edge of the plastic body that allow an inspector to observe the top of the through hole
Electronics Forum | Wed Nov 21 06:01:57 EST 2018 | premkumar_haribabu
Hi Davef, Thanks for your quick reply , just my inputs - we using 99.99 % pure nickel strip for soldeirng & when we do manual soldering this nickle stips its working well but when coming to SMT reflow even after high peak temperature ,its removes ev
Electronics Forum | Tue Dec 11 14:49:14 EST 2018 | tey422
We have one, but seem like we hardly use it that much though. I would say it's useful, but not exactly must to have. Most of the models out there would not come with the marking vision system, but you can add it as option. The tricky part of using
Electronics Forum | Fri Jan 04 22:23:23 EST 2019 | ameenullakhan
Hi, Here we take profile for every changeover. And we compare it with our profile.For the oven performance. We daily take a minimum of 3 profile for one oven. We have High mix low volume production. We are using ORH1 ( organic flux with halid cont
Electronics Forum | Fri Jan 11 11:01:04 EST 2019 | jbhakta
Hello All, We have a MPM AP25. Couple weeks ago we booted it up and got a "CMOS battery state low" warning. It asked us to fit F1 to RESUME. After that it asks for a ROM password. After incorrectly typing in a password - it asks for Boot Disk in the
Electronics Forum | Tue Feb 05 13:14:27 EST 2019 | youngbuck
Hi Steve, Have you took the star completely off the Gantry. There are the 12 hoses to the star if Segment 1 connection hose is messed up everything will be off because everything gets measure off of Seg.1. Also, you could start eleiminating the probl
Electronics Forum | Wed May 22 11:58:32 EDT 2019 | emeto
If the setup is not huge, I would say get the ASM. They have great setup optimizer. You can have multiple reels if the same parts on the setup and have all the setup in front of the machine, so your operator don't have to circle around all the time.
Electronics Forum | Mon May 06 11:45:32 EDT 2019 | slthomas
There are quite a few papers out there on the subject. Just enter "SMT void reduction" into google or other search engine and take your pick. That said, slow ramp rates and paste volume reduction are a good place to start. Although I haven't tried i
Electronics Forum | Mon Jun 10 09:12:18 EDT 2019 | pcbconnectchina
Hello! Don, Yes, if the carrier is steel/stainless, it would be very hot when it comes out from oven. I heard that durostone (synthetic stone) carrier can meet your requirement, it can stand high temperature with low thermal transmission. So when it