Electronics Forum | Mon Nov 21 11:21:15 EST 2005 | stepheniii
He's not talking about the balls. He's talking about the sheilding. As soon as I saw the data sheet and all it's warnings, I thought o crap. Anyways the customer had checked all 5 before giveing them to us. After 4 failed. MuRata said the profile we
Electronics Forum | Mon Nov 21 16:29:02 EST 2005 | pjc
Here is Manix web site: http://www.manixmfg.com/ Yes, the zone temps can be set high, but the thermal transfer efficiency is very low. I was profiling one of these ovens last week. To get 215C on the board you have to set the zone temp well over 30
Electronics Forum | Tue Dec 13 20:56:54 EST 2005 | Kathy-Sunnyvale
Dear All, Our star-up company will be operated in soon, but I still have many questions and concerns about SMT pick&place machine (being good for 0402 and BGA componens)since there have too many kind of machine with various grand name such as Amist
Electronics Forum | Thu Dec 15 06:20:11 EST 2005 | rlackey
Hi Liza, We've seen it occaisionally in house on Universal GSM 8,12,16mm but not on Fuji (except when a feeder's not used for a while). Also on 44, 56 & 72mm (the smaller vol parts I mentioned earlier. It tends not to affect the Hoover Davis Feeder
Electronics Forum | Thu Dec 15 08:09:06 EST 2005 | GS
Hi Liza, several years ago we had problem like that only with Carrier Tape made by Ploycarbonate material and by using High Speed pick & place. Very few pbms met by using low speed P&P machine. Problems have been solved by using Polystirene Carri
Electronics Forum | Thu Dec 15 17:30:42 EST 2005 | GS
Yes Davef, storage condition and long time remaining on shelf could effect pealing strength, but we experimented that by using Polystirene Carrier Tape also this problem was reduced almost to zero. Df, If I am not wrong when you talk about pr
Electronics Forum | Thu Dec 15 23:04:07 EST 2005 | Manyhats
Hello, we are a low volume high mixed CM looking for a new addition to our SMT depot. We are currently running 2 Mydata TP-11 Hydra and feel that this can not meet our 06' forcast and current builds. I need to make a decision whether to go with the S
Electronics Forum | Tue Dec 27 10:57:20 EST 2005 | DannyJ
I'm not sure if I understand the question correctly... Mainly, drill the mushroomed end of the rivet with a drill bit that is slightly larger than the shaft size of the rivet and remove the cover. Then, you should have easy access to what you need t
Electronics Forum | Fri Feb 03 17:47:06 EST 2006 | Brian Smith
Kester offers Tin-Copper AND Tin-Copper-Nickel. The Kester K100 alloy is a Tin-Copper-Nickel material that is very similar to SN100C. Straight Tin-Copper isn't tremendously popular but can be used in low-cost, consumer-electronics applications wher
Electronics Forum | Thu Feb 16 06:37:07 EST 2006 | Mity-C
Good Morning jobbie, We have several Mydata lines. We are building low volume high mix as well. Our CPH had been identified as approximately 6000-8000 CPH depending on the application of course. We do have a separate setup area however that stages a
