Electronics Forum | Sun Feb 18 14:46:11 EST 2001 | CAL
Some key data is needed 1) how often does the HS 50 machines run? 24/7? 2)How many placements are being performed? I know for a fact Siemens Siplace S/F platforms require weekly preventative maintenance. Knowing the sophistication of the HS platform
Electronics Forum | Wed Aug 03 11:08:24 EDT 2005 | PWH
We use the following stuff from "Biral USA": BIO30 Synthetic High Temp Oil � Chain Oilers NMG-400G � No melt grease - miter gears/lead screws AS500ML � Anti-size spray - lead screws, drive sprockets, rail support L-brackets It seems to work good
Electronics Forum | Fri Nov 18 10:05:28 EST 2005 | lgroves
most pick and place machines will run for a very long time provided the operators keep them clean and well lubricated (10 years +). Often we end up replacing equipment not due to inoperability as much as due to capability. as packages and use chang
Electronics Forum | Fri Jan 13 06:54:12 EST 2006 | pjc
Here's a couple more: Vitek Coating Div., Vitek Research Corp. - Derby, CT - Contact Service Company Company Profile: Parylene Conformal Coating Services With Plasma Surface Treatment To Enhance Adhesion. Electrostatic Powder & Liquid Coating Of Med
Electronics Forum | Sat Jan 21 19:44:07 EST 2006 | vincent
i have a problem similar to Daxman where cp6 usually having problem when it run at high speed, the head seems to have problem returning back to its origin at st12 and stop at st15 and st19 for nozzle change error, when rotating the head by hand, some
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Fri Jun 16 15:50:08 EDT 2006 | Bert van den Berg
PSA - Pressure Sensitive Adhesive? I don't know which type of tape the affected reels of parts use but it is not sticky. Thanks everyone for the comments and suggestions. There were no missing teeth on the plastic take-up reels. I have cleaned an
Electronics Forum | Mon Jul 03 23:29:26 EDT 2006 | grantp
Hi, Don't know about your machines, but our XP Fuji machines have a lubrication tube linking the under side of the machine to the top, so you can put a grease gun on it, and push grease into hard to reach places. Does yours have that? If your heari
Electronics Forum | Tue Sep 19 14:52:40 EDT 2006 | bobpan
Grease every 2-6 months depending on the hours used. Dont overgrease.....and make sure you wipe off all excess grease after lubing because the grease always tends to get into the horseshoe sensors and then you will get motor error 4's untill you die!
Electronics Forum | Mon Oct 02 17:31:40 EDT 2006 | daxman
ARGGH! I've verified proper airflow, made sure everything is tight and secure, cleaned and lubricated the bearings and nothing seems to help. first few boards are nice...then the next few are really bad..then they kinda get good again. I have no ide