Electronics Forum | Wed Jan 16 18:13:50 EST 2008 | peshlakai74
We have a Seho 1135-F Soldering wave. Everytime we shut the machine off it asks for a password. We call for service and we get a new one. Is there a way i can by pass the password? Thanks.
Electronics Forum | Fri Jan 25 11:49:09 EST 2008 | toddl
Hi all, I have an inconsistent situation. Lately, we seem to have excessive dross buildup in the solder pot which inturn causes the pot to overflow. Has anyone had a similar experience? Here are the details: age of machine= 9 years, flux used= Kester
Electronics Forum | Wed Jan 30 10:21:36 EST 2008 | jax
Haven't used Quad in a long time but here is what I have in my system for that item: Precision Placement Machines, Inc. (Fremont, NH) Part # 5-1567-025-5 Price $1750.00 Contact Info: Phone # 603-895-5112 Quad will charge around $2750.00
Electronics Forum | Thu Jan 31 09:07:25 EST 2008 | aj
Hi, we have the same problem here but have a solution. We have Fuji FIP3 machines but this should be the same for all - use the tube that the parts are in for part presentation ! i.e. cut out a window big enough at the top of the tube for the nozzl
Electronics Forum | Fri Feb 01 09:34:54 EST 2008 | jdengler
In the PD for 0603 I have a min size of 0.7mm and a max size of 1.0mm and the CP4 size at 0.0mm. This way when you have 1.0mm nozzles in the machine it will use that and when you change them to 0.7mm it will use that. Both sizes work OK. -Jerry
Electronics Forum | Tue Feb 05 18:26:34 EST 2008 | janz
Hello, We have FCM base 2 machine (Philips-Assembelon). I am trying to find out whether it is possible to install instead vacuum pump (make noise and power consumption) venturi system. Does anyone try to do this.? What was the result.? What vent
Electronics Forum | Tue Feb 19 14:52:04 EST 2008 | dphilbrick
You also need to understand when using something like a Q Cutter you should resolder the board after you cut! Your alternative is to get someting that when you put your part in it cuts and clinces the part. Contact Systems makes machines that present
Electronics Forum | Fri Feb 22 10:27:03 EST 2008 | fastek
Well I've heard you must get the 0201, 0.4mm tape feeder to place an 0201 component as the 0402 feeder won't do it. They ain't cheap @ $1,000 each from Fuji roughly. Also you will need to get 0.4mm nozzles on your machine. Have you actually done thi
Electronics Forum | Fri Feb 22 13:17:56 EST 2008 | cyber_wolf
0201 Feeders are a different height than regular 8X2's I have put them on a surface plate and measured them with a height gauge. FYI: They make 0201C (Capacitor) and 0201R (Resistor)Again the difference between the two is height. Also it is CRITI
Electronics Forum | Tue Feb 26 19:24:22 EST 2008 | swag
We're in the market for a new depaneling router for high volume flex circuit builds. I have no experience with them. At this time, we do all our low volume stuff on a 3-axis mill. Any advice on what to consider and some recommendations of the best
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477