Electronics Forum | Sat Mar 13 01:29:16 EST 1999 | Mike Konrad
Greetings Bill, My� Aren't we just a little sensitive! Isn't the purpose of this forum to educate, exchange ideas, provide alternative solutions??? Or is it an open-ended venue for the advertisement of one specific machine from one specific manuf
Electronics Forum | Wed Mar 10 16:18:52 EST 1999 | Raymond Morford
I'm in the process of selecting a medium speed pick & place machine. I need to place a wide range of components from 0805 chips to a 144 pin MQFP (32mm square 25mil lead spacing). Anyway, I'm looking at the Quad QSA-30, the Philips Orion (now call
Electronics Forum | Wed Mar 10 18:35:20 EST 1999 | Earl Moon
| I'm in the process of selecting a medium speed pick & place machine. I need to place a wide range of components from 0805 | chips to a 144 pin MQFP (32mm square 25mil lead spacing). | | Anyway, I'm looking at the Quad QSA-30, the Philips Orion |
Electronics Forum | Sun Mar 07 08:02:40 EST 1999 | Earl Moon
| My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The v
Electronics Forum | Wed Mar 10 10:11:10 EST 1999 | Justin Medernach
| | My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The
Electronics Forum | Mon Mar 01 23:57:00 EST 1999 | Erhan Kaya
"DIP, VCD" -> "smt secondary" type of process flow. In that case, dispensing becomes a must. Dispensing needs less setup than printing, but takes longer. So, for a prototype manufacturer, dispensing becomes the best choice. Sometimes a machine dispe
Electronics Forum | Thu Mar 04 14:20:48 EST 1999 | Greg Valdman
| For as much as you can minimize bridging in these condition by changing board orientation, the only way to eliminate them may be to add debridging airknife tech to your system, or purchase a system that is fitted with this technology. We have been
Electronics Forum | Mon Feb 22 15:46:05 EST 1999 | Earl Moon
| Hello | Is there anyone who can give me some information regarding yield from gluing 0603 | Is there any other problems that you might have had. | | We glue bottom side 0603's but have changed our pad spacing to accomodate tolerance requirements
Electronics Forum | Wed Feb 03 21:46:33 EST 1999 | Larry Mara
Steve, We are in the same boat--small and limeted on fund.We have a TF200 that pace is letting us demo, seems like good tool that we can add to as we need to.We are going to buy one.Great
Electronics Forum | Tue Jan 26 00:21:29 EST 1999 | Parvez Patel
Ya I agree with Dean. We've done quite a lot of work with the SRT Summit2000 rework station.The results have been satisfactory, to say the least. One should however characterize the different operating parameters:namely the working scavenger air flow
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477