Electronics Forum | Tue Oct 21 04:45:13 EDT 2008 | stanyserrao
Head 1 is not placing the parts in production. Same component is placed by head 2. Head 1 camera is camera 12 type and head 2 camera is type 8. Machine re-set done resent proper data and interchanged cameara still same problem was foundd in head 1.
Electronics Forum | Fri Oct 24 07:44:05 EDT 2008 | leemeyer
Yep there are nozzles on both machines. This is a very quirky program. I remember when I first loaded it I couldn't get it to run. I reloaded several times, double checked all of the settings in the autoexec and config.sys files but couldn't get it
Electronics Forum | Fri Oct 24 10:17:27 EDT 2008 | janz
Hello, I am trying use PMJ1800 odd form machine to place axial components. If I set clencher hight according to manual (so clencher nearly touching PCB) one lead is cleached more or one side i pulled more. I have checked clencher position and it is
Electronics Forum | Mon Nov 10 13:14:34 EST 2008 | evtimov
Hello Hoss, try with the flux again. I would first change the flux. Alcohol based for me is always better. But you can try water based too. 1. Change the flux 2. Go with more pressure on your atomizer(or whatever they call it on your machine). Just
Electronics Forum | Mon Nov 10 16:43:24 EST 2008 | markgray
Steve, I finally played with it enough that it is working again. I ended up with Edge Threshold: 19; Intensity Threshold: 60; Offset: 200; Gain: 16 The problem seemed to be with the Intensity Threshold. I was not getting an error code on the screen
Electronics Forum | Tue Nov 25 05:40:52 EST 2008 | wanderson
Calibration menu and then Index Cam Setup and follow the on screen instructions. (You can skip the focus step if you have not adjusted the camera's) The point you need to pay particular attention to is when it displays the intensity histogram, this
Electronics Forum | Sun Nov 16 08:39:30 EST 2008 | davef
No, we didn't know UK based service support for your machine from a bread box, but maybe these people can help you: * Wolfgang M�ller, Technical Sales, Technical Manager, +49 7348 9855 15, F+49 7348 9855 8 15, M +49 175 58 39 611 Wolfgang.Mueller@asy
Electronics Forum | Fri Nov 21 06:00:56 EST 2008 | ralphspm
Our Fuji IP2 m/c will not recognise fiducial marks. M/c lost all proper data and without any backup documentation on what data was originally inputted I have had to use educated guesswork. Is there info that needs to be in the proper data for the IP2
Electronics Forum | Mon Dec 01 12:25:22 EST 2008 | markhoch
I can't help you much there, but I do have a couple of manuals for a TDK RX-40!! Ha! That machine brings back memories....operator forgets to lock a feeder down, and in about thirty seconds, you have 140 nozzles with the tips ripped off. Ahhh...those
Electronics Forum | Fri Dec 19 10:18:05 EST 2008 | dyoungquist
On TH parts we have been hand soldering. This last summer we purchased a Rhythm selective solder machine from RPS automation. I did a factory tour of both RPS and ACE since both facilities are about 1/2 mile from each other. In comparing the 2 c
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477