Electronics Forum | Thu Sep 08 15:22:32 EDT 2016 | bobpan
If its a tall part and you are trying to scan it lower than 200 or so...you can have this problem (limit error). Thinking of things to look at.....Is your z-rod spring sticking? Push up on it and it should spring back with NO hesitation...if it does.
Electronics Forum | Fri Aug 26 19:59:02 EDT 2016 | mhanrahan
We've just purchased a CP45FV Neo to replace an ancient Panasonic line. First non-Panasonic placement equipment I've worked on, so learning as I go here. So far it's been pretty straightforward. However, we use some parts that come in QFN or LCC p
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Thu Sep 01 12:07:35 EDT 2016 | pavel_murtishev
Is there any field proven spray cleaning technique able to remove flux residues under OSRAM LEDs? Is it possible in principle? The problem is that OSRAM LEDs are low standoff ones and I absolutely have no idea how cleaning agent could get there. Mo
Electronics Forum | Thu Sep 08 12:37:55 EDT 2016 | mmjm_1099
We stated placing labels on our lines for a couple years now and over the past year it has really taken off. Hover-Davis is the place you need to contact in order to get the correct feeder for your machines. They will want a single column label with
Electronics Forum | Tue Sep 13 10:00:27 EDT 2016 | awhite
Switched out the mech. relay on the board loader, no change. Same behavior. Could not find a mech. relay on the printer... SMEMA wiring appears go directly to a PCB. And it is at that point that I run out of talent. If the machine weren't dedicate
Electronics Forum | Mon Oct 03 05:10:19 EDT 2016 | robl
Hi Nikhilesh, It was a long time ago, but we used to buy the nickel in reels then had a cut and feed station on the smt machine with selectable sizes. We did many types of boards in very large volumes, and usually the Nickel strip was soldered to t
Electronics Forum | Sun Oct 09 22:07:51 EDT 2016 | geniepro
I would like to ask after glue bonding is abalibity drop. I test by force equipment that it is very difficult to drop after reflow 2. Very due by DIP machine. I check after Dip many chip drop. I wonder the glue not qualify I am using IR 130. Could yo
Electronics Forum | Fri Nov 04 15:16:09 EDT 2016 | mmjm_1099
Couple things here that could be the caused. Option 1: Error pass, Option 2: Vacuum release issues, Option 3: Magnetized nozzles (I have seen this occur by purchasing cheap nozzles), Option 4: Dirty Nozzles. Currently have two CP43 and one CP42 that
Electronics Forum | Wed Nov 30 15:04:22 EST 2016 | warwolf
We have two of them set up in our line they where made in 2011. we place Atmel AT91SAM9G45-CU 324-ball BGA no issues and other larger PCB blutooth IC's,QFN,QFP full range of sizes. You can make your own profiles for the parts to be recognised if you
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
