Electronics Forum | Sat Apr 24 04:41:56 EDT 1999 | Murray Pulman
Dear C.K We are routinely wave soldering 0603 and sot23 on subcontract, hence we get what we are given!!. Being UK based we use a Blundell cms 400 dual wave soldering machine (made in Coventry), Tecan Stencils and Loctite 3612 adhesive. You must k
Electronics Forum | Tue Apr 27 12:04:44 EDT 1999 | Bob
I hope I'm not too late with some help for you. I have purchased stainless steel wire cleaning baskets for a vapor degreaser from: Cooley Wire Products 5025 North River Road Schiller Park, IL 60176 847-678-8585 fax 847-678-8612 They do a very nice
Electronics Forum | Tue Apr 20 23:18:48 EDT 1999 | KEVIN SIMPSON
25 PPM)! | | 1. Is there a better process to solder the leads of QFP's with lifted "minute" lifted leads still having a realiable solder joints? | | 2. Or has anybody tried modifying solder pads and use thicker solder paste deposit to compensate fo
Electronics Forum | Tue Apr 06 16:22:58 EDT 1999 | Dave F
| 0603's and 0402's are being damaged by the water wash post reflow. PCA's are 1" X 4" and 2" X 2" approximately. | | We've adjusted water pressure so that the top-down is higher than the bottom up. | | The baskets have a .5" mesh spacing. Some
Electronics Forum | Thu Mar 25 16:59:20 EST 1999 | RAG
| maybe someone can help me with this | problem I have 4 S-20 machines on 3 | lines and I notice that when I omit | a component on the station computer | other components are not assembled | and on each PCB it's different | components and not the s
Electronics Forum | Fri Apr 09 10:53:54 EDT 1999 | RNLM
| | maybe someone can help me with this | | problem I have 4 S-20 machines on 3 | | lines and I notice that when I omit | | a component on the station computer | | other components are not assembled | | and on each PCB it's different | | components
Electronics Forum | Tue Mar 23 12:55:47 EST 1999 | Dave F
| I am looking for clip art images of electronics assembly. Images like wave soldering, surface mount components, soldering irons... just general assembly graphics. Many sites have different individual images that they use I was just wondering if a
Electronics Forum | Sat Mar 20 00:29:07 EST 1999 | Vinesh Gandhi
| | Hi Folks, | | This is my first surface mount board, so I asked our assembly house for some tips. They said only passives on the bottom side-preferably no smaller than 0805, 0603 only if I have to. I would think that an SOT-23 would be OK on the b
Electronics Forum | Thu Jun 03 01:33:40 EDT 1999 | Bubba
| Here is my question. We have several fuji CP's in our shop, every once in a while the first couple of parts placed are off the pads. When we move the parts further down in the sequence they are fine. What is going on? Has anyone had this problem an
Electronics Forum | Mon Mar 15 09:55:53 EST 1999 | Justin Medernach
| After rmoving a BGA (plastic)to correct unexplained shorts | I installed another BGA using flux only. | Checking on an X Ray machine and found two shorts. | | can anyone give a good explenation ? | | Thanks | | Ron | Ron, It could be a number o
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477