Electronics Forum | Mon Jul 29 08:28:05 EDT 2002 | pjc
Start killing DEK now, on the ELA. All DEK 248 semi-auto printers have been built in China for quite some time (years). Its shipped to the UK from China. All DEK ELA models are now built in China, since 01 some time. Thats the fact Jack. All MPM mod
Electronics Forum | Mon Aug 12 18:26:05 EDT 2002 | pjc
If you are talking actual placement rate- from first fiducial read of board no. 1 to first fiducial read of board no. 2, here is the best I've ever seen based on the boards I've run: CP3- 141 seconds for 468 components per board (all rectangular chi
Electronics Forum | Mon Aug 19 11:13:18 EDT 2002 | ksfacinelli
I would like to understand what different options people are using to place low volume / odd form parts. I am very familiar with the tweezers / vacuum pen method however this can be less than desirable. I am looking into a manual pick and place to
Electronics Forum | Tue Aug 27 13:52:24 EDT 2002 | Mike Konrad
MK, In most cases, if the machine is completely closed-looped (prewash, wash, prerinse, rinse, final rinse etc), then the water should not require changing. As with most inline cleaners, there should be a considerable amount of water loss in the cl
Electronics Forum | Mon Sep 09 13:41:38 EDT 2002 | cp743
Mr. Bentzen, Good morning. We at Fuji have no record of any customer bringing to our attention this issue. We have never had an issue handling these parts to date. The errors that you are encountering are related to an incorrect vision type. You s
Electronics Forum | Tue Sep 10 23:37:22 EDT 2002 | Steve E
Dear Sir I can assure you that I have personal experience with the part in question.This part will run with the recommend vision types ( 11 & 12 ). I noticed You neglected to state how old the machine was, and the amount of hours. The CP-6 series hav
Electronics Forum | Thu Aug 29 20:01:23 EDT 2002 | davef
Many people use the same spacing [and pad designs] as they use for primary side SMT. We don�t. DOWN STREAM SMT-TO-SMT SPACING: In addition to proper orientation, components cannot be immediately upstream of terminations that are to be soldered or b
Electronics Forum | Fri Sep 06 15:22:53 EDT 2002 | barryg
Genny, we recently went through the same scenerio. First to consider is your budget. Second , what type of components (fine pitch, bga, chip components)that you would be placing. Also consider board size max. that you would be doing and would see you
Electronics Forum | Tue Sep 17 12:38:17 EDT 2002 | stepheno
If you have a newer style MPA like the MPA-G3, check out http://www.hoverdavis.com/Products/mpp/mpp.htm I find them much better than the panasonic feeders. You may have to set pitch to 2 or 3 because of timeing issues, or you can change the NC progr
Electronics Forum | Wed Sep 18 10:06:30 EDT 2002 | Bob M
I place 15-20 mil a lot. You need to look at your pad to apature reduction. Your stencil thickness. The type of paste your using. We use 2-5 mil reduction on each side as a general rule on fine pitch. This varies depending on pad width. We also use 5
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477