Electronics Forum | Fri Jan 07 01:28:54 EST 2000 | Dennis O'Donnell
This is a common type of connector. We press them in daily. AMP has a lot of different type of tools and machines available for connectors. We just use a local machine shop to make jigs that fit a standard 2 ton press. It is quicker and les cos
Electronics Forum | Mon Dec 20 17:30:30 EST 1999 | g cronin
bill is right about finding a reputable dealer, i do have a horror story about buying a machine that was not what it was sold to be. But there are some good ones out there.. if you do have interest in a machine feel free to ask the forum our opinion
Electronics Forum | Tue Dec 21 12:47:25 EST 1999 | Larry
Clarissa, Like any used equipment, make sure both you and the dealer know what you expect from the machine. Ask questions! Make sure you understand what is involved in the refurbishment, if anything. Things like Technical support will be important if
Electronics Forum | Sat Dec 11 11:01:11 EST 1999 | Mark W.
In answer to your question no. Fiducials should always be as far apart from each other in both directions (X,Y) as possible. This will allow ANY placement machine to calculate the EXACT location and rotation of the PCB, and therefore correct the moun
Electronics Forum | Tue Dec 07 21:38:54 EST 1999 | Sosina outry
Correct me if i am mistaken, I always hear the circle is better fid mark than any. Due to shape and dimension, one value of diameter is needed while square you need width and lenght. beside whichever fid mark, the accuracy will base on cad and techn
Electronics Forum | Wed Nov 03 03:26:38 EST 1999 | Wes
We have Siemens S-20 machine whose other gantry occasionally missmounts all its components in Y-direction(approx. 1/2 mm ). Most of the missmounts happens when there is a lot of 0603 or 0805s (B-side glue boards). Gantry picks up the components OK bu
Electronics Forum | Wed Oct 20 05:13:24 EDT 1999 | Paul Gerits
Hi Jorge, As you know SMEMA is a world standard (means it is the same at every vendor and each machine), at DEK you can buy (if not already implemented in your printer) SMEMA communication option. This is a pcb which is set in the machine to enable
Electronics Forum | Sun Oct 17 23:17:01 EDT 1999 | MJI
I'm interested in the various ways to assure that the fingers on a wave machine are not bent or crooked - beyond a monthly or quarterly maintenance regimen. In fact, how do you know all's well even right after maintenance? That is, making sure that
Electronics Forum | Mon Oct 11 17:15:03 EDT 1999 | Mike H
| Just curious as to everyones thoughts on if you could chose to use F4G or an MCS-30. Which would you chose and why? | | | Larry J | |Larry, depending to your Fuji machines, if you are using any new machines like QP1 or QP2 and any other ones li
Electronics Forum | Mon Oct 18 08:27:54 EDT 1999 | Bruce
buy a MCS-30, which you will use only to transmit programs to machines." If your really looking for the right software, contact Fuji about their latest software labeled FujiCam (Unicam). I don't think you can buy F4G software anyway. I guess it all d
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477